MB95107B データシートの表示（PDF） - Fujitsu

部品番号

コンポーネント説明

メーカー

MB95107B

8-bit Proprietary Microcontrollers

Fujitsu 

MB95100B Series

(Continued)

Part number

Parameter

MB95107B

MB95F108BS/

MB95F108BW

MB95R107B*3

MB95D108BS/

MB95D108BW

Two clock modes and two counter operating modes can be selected. Square wave form

16-bit reload timer

output

Count clock : 7 internal clocks and external clock can be selected.

Counter operating mode : reload mode or one-shot mode can be selected.

Each channel of the timer can be used as “8-bit timer × 2 channels” or “16-bit timer × 1

8/16-bit compound

timer (2 channels)

channel”.

Built-in timer function, PWC function, PWM function, capture function and square

wave form output

Count clock : 7 internal clocks and external clock can be selected.

16-bit PPG

(2 channels)

8/16-bit PPG

(2 channels)

PWM mode or one-shot mode can be selected.

Counter operating clock : Eight selectable clock sources

Support for external trigger start

Each channel of the PPG can be used as “8-bit PPG × 2 channels” or “16-bit PPG × 1

channel”.

Counter operating clock : Eight selectable clock sources

Watch counter

(for dual clock

product)

Count clock : Four selectable clock sources (125 ms, 250 ms, 500 ms, or 1 s)

Counter value can be set from 0 to 63. (Capable of counting for 1 minute when selecting

clock source 1 second and setting counter value to 60)

Watch prescaler

(for dual clock

product)

4 selectable interval times (125 ms, 250 ms, 500 ms, or 1 s)

External interrupt Interrupt by edge detection (rising, falling, or both edges can be selected.)

(12 channels)

Can be used to recover from standby modes.

Flash memory

Supports automatic programming, Embedded AlgorithmTM *6

Write/Erase/Erase-Suspend/Resume commands

A flag indicating completion of the algorithm

Number of write/erase cycles (Minimum) : 10000 times

Data retention time : 20 years

Erase can be performed on each block

Boot block configuration

Block protection with external programming voltage

Flash Security Feature for protecting the content of the Flash

Standby mode

Sleep, stop, watch (for dual clock product), and timebase timer

*1 : Specify clock mode when ordering MASK ROM.

*2 : MB95F108BS/MB95D108BS is single clock and MB95F108BW/MB95D108BW is dual clock.

*3 : This device is under development.

*4 : For details of option, refer to “■ MASK OPTION”.

*5 : MB95D108BS/D108BW/R107B contain 4 general-purpose I/O ports for N-ch open drain. Port number other

than MB95D108BS/D108BW/R107B has 6 general-purpose I/O ports for N-ch open drain.

*6 : Embedded Algorithm is a trade mark of Advanced Micro Devices Inc.

Note : Part number of the evaluation products in MB95100B series is MB95FV100D-101. When using it, the MCU

board (MB2146-301A) is required.

4

Share Link: