M29F002 データシートの表示（PDF） - Fujitsu

部品番号

コンポーネント説明

メーカー

M29F002

2M (256K X 8) BIT FLASH MEMORY

Fujitsu 

MBM29F002TC-55/-70/-90/MBM29F002BC-55/-70/-90

Erase Suspend

The Erase Suspend command allows the user to interrupt a Sector Erase operation and then perform data reads

from or programs to a sector not being erased. This command is applicable ONLY during a Sector Erase operation

which includes the time-out period for sector erase. The Erase Suspend command will be ignored if written

during the Chip Erase operation or Embedded Program Algorithm. Writing the Erase Suspend command during

the Sector Erase time-out results in immediate termination of the time-out period and suspension of the erase

operation.

Any other command written during the Erase Suspend mode will be ignored except the Erase Resume command.

Writing the Erase Resume command resumes the erase operation. The addresses are DON’T CARES when

writing the Erase Suspend or Erase Resume command.

When the Erase Suspend command is written during the Sector Erase operation, the device will take a maximum

of 15 µs to suspend the erase operation. When the device has entered the erase-suspended mode, the DQ7 bit

will be at logic “1”, and DQ6 will stop toggling. The user must use the address of the erasing sector for reading

DQ6 and DQ7 to determine if the erase operation has been suspended. Further writes of the Erase Suspend

command are ignored.

When the erase operation has been suspended, the device defaults to the erase-suspend-read mode. Reading

data in this mode is the same as reading from the standard read mode except that the data must be read from

sectors that have not been erase-suspended. Successively reading from the erase-suspended sector while the

device is in the erase-suspend-read mode will cause DQ2 to toggle. (See the section on DQ2.)

After entering the erase-suspend-read mode, the user can program the device by writing the appropriate

command sequence for Byte Program. This program mode is known as the erase-suspend-program mode.

Again, programming in this mode is the same as programming in the regular Byte Program mode except that

the data must be programmed to sectors that are not erase-suspended. Successively reading from the erase-

suspended sector while the device is in the erase-suspend-program mode will cause DQ2 to toggle. The end of

the erase-suspended program operation is detected by Data polling of DQ7, or by the Toggle Bit I (DQ6) which

is the same as the regular Byte Program operation. Note that DQ7 must be read from the Byte Program address

while DQ6 can be read from any address.

To resume the operation of Sector Erase, the Resume command (30H) should be written. Any further writes of

the Resume command at this point will be ignored. Another Erase Suspend command can be written after the

chip has resumed erasing.

15

Share Link: