MC56F8013PB データシートの表示（PDF） - Freescale Semiconductor

部品番号

コンポーネント説明

メーカー

MC56F8013PB

16-bit Digital Signal Controllers

Freescale Semiconductor 

Award-Winning Development Environment

PWM frequency. Edge-aligned and center-aligned synchronous pulse width control (0% to 100%

modulation) is supported. The device is capable of controlling most motor types: ACIM (AC Induction

Motors), both BDC and BLDC (Brush and Brushless DC motors), SRM and VRM (Switched and Variable

Reluctance Motors), and stepper motors. The PWM incorporates fault protection and cycle-by-cycle

current limiting with sufficient output drive capability to directly drive standard optoisolators. A

“smoke-inhibit”, write-once protection feature for key parameters is also included. A patented PWM

waveform distortion correction circuit is also provided. Each PWM is double-buffered and includes

interrupt controls to permit integral reload rates to be programmable from 1/2 (center-aligned mode only)

to 16. The PWM module provides reference outputs to synchronize the Analog-to-Digital Converter

(ADC) through Quad Timer, Channels 2 and 3.

This Digital Signal Controller also provides a full set of standard programmable peripherals that include

one Serial Communications Interface (SCI), one Serial Peripheral Interface (SPI), one Quad Timer, and

one Inter-Integrated Circuit (I2C) interface. Any of these interfaces can also be used as General Purpose

Input/Outputs (GPIOs).

1.3 Award-Winning Development Environment

Processor ExpertTM (PE) provides a Rapid Application Design (RAD) tool that combines easy-to-use

component-based software application creation with an expert knowledge system.

The CodeWarrior Integrated Development Environment is a sophisticated tool for code navigation,

compiling, and debugging. A complete set of evaluation modules (EVMs), demonstration board kit and

development system cards will support concurrent engineering. Together, PE, CodeWarrior and EVMs

create a complete, scalable tools solution for easy, fast, and efficient development.

1.4 Architecture Block Diagram

The 56F8013’s architecture is shown in Figure 1-1, Figure 1-2, and Figure 1-3. Figure 1-1 illustrates

how the 56800E system buses communicate with internal memories and the IPBus Bridge. Table 1-1 lists

the internal buses in the 56800E architecture and provides a brief description of their function. Figure 1-2

and Figure 1-3 show the peripherals and control blocks connected to the IPBus Bridge. The figures do not

show the on-board regulator and power and ground signals. They also do not show the multiplexing

between peripherals or the dedicated GPIOs. Please see Part 2 Signal/Connection Descriptions to see

which signals are multiplexed with those of other peripherals.

1.4.1 PWM, TMR and ADC Connections

Figure 1-3 shows the over/under voltage connections from the ADC to the PWM and the connections to

the PWM from the TMR and GPIO. These signals can control the PWM outputs in a similar manner to the

over/under voltage control signals. See the 56F8000 Peripheral Reference Manual for additional

information.

The PWM_reload_sync output can be connected to the TMR channel 3 input and the TMR channels 2 and

3 outputs are connected to the ADC sync inputs. These are controlled by bits in the SIM Control Register;

see Section 6.3.1.

56F8013 Technical Data, Rev. 2

Freescale Semiconductor

7

Preliminary

Share Link: