ML6599CT データシートの表示（PDF） - Micro Linear Corporation
部品番号
コンポーネント説明
メーカー
ML6599CT Datasheet PDF : 8 Pages
| |||
being hot-inserted/removed should be inactive
(accomplished by grounding the DISCNKT pin in the case
of the ML6599). If the terminator being inserted/removed
were in the active state, at some point in time the bus
would be terminated by either 1 or 3 terminators. In either
case, data integrity on the bus will be compromised.
Figure 2 gives an application diagram showing a typical
SCSI bus configuration. To ensure proper operation, the
TERMPWR pin must be connected to the SCSI
TERMPOWER line. Each ML6599 requires parallel 0.1µF
and 10µF capacitors connected between the VREF and
GND pins and the TERMPOWER line needs a 10µF
bypass capacitor at each node in the system.
In an 8-bit wide SCSI bus arrangement (“A” Cable),
two ML6599s would be needed at each end of the SCSI
cable in order to terminate the 9 active signal lines.
16-bit wide SCSI would use three ML6599s, while 32-bit
wide SCSI bus would require five ML6599s.
In a typical SCSI subsystem, the open collector driver in
the SCSI transceiver pulls low when asserted. The
ML6599
termination resistance serves as the pull-up when negated.
Figure 2 also shows a typical cable response to a pulse.
The receiving end of the cable will exhibit a single time
delay. When negated, the initial step will reach an
intermediate level (VSTEP). With higher SCSI data rates,
sampling could occur during this step portion. In order to
get the most noise margin, the step needs to be as high as
possible to prevent false triggering. For this reason the
regulator voltage and the resistor defining the MOSFET
characteristic are trimmed to ensure that the IO is as close
as possible to the SCSI maximum current specification.
VSTEP is defined as:
VSTEP = VOL + (IO × ZO)
where VOL is the driver output low voltage, IO is the
current from the receiving terminator, and ZO is the
characteristic impedance of the cable.
This is a very important characteristic that the terminator
helps to overcome by increasing the noise margin and
boosting the step as high as possible.
0.1µF
10µF
ML6599
TERMPWR LINE
VREF
TERMPWR
GND DISCNKT
L9 . . . L2 L1
SCSI CABLE
ML6599
TERMPWR
VREF
DISCNKT GND
L1 L2 . . . L9
0.1µF
10µF
SCSI XCVR
SCSI XCVR
SCSI XCVR
VREG
tD
tD
LINE ASSERTED LINE NEGATED
VREG
VSTEP
VOL
Figure 2. Application Diagram Showing Typical SCSI Bus Configuration with the ML6599
5
Share Link: 