MLO81100-01960 データシートの表示（PDF） - Tyco Electronics
部品番号
コンポーネント説明
メーカー
MLO81100-01960 Datasheet PDF : 2 Pages
| |||
Surface Mount Voltage Controlled Oscillator
MLO81100-01960
MLO81100-01960
Surface Mount Voltage Controlled Oscillator
PCS 1930 - 1990 MHz
Features
• Miniature Size
• Surface Mount Package
• Electrically Shielded
• Low Phase Noise
• Highly Linear Tuning
LSM1 Package
Description
The MLO81100-01960 is a fundamental single ended oscillator
designed for use in cost sensitive wireless and telemetry applica-
tions. The device has been optimized by careful selection of the
bipolar transistor and varactor diode for low phase noise and high
linearity tuning characteristics.
The low profile surface mount package used provides for
electrical shielding, ease of assembly and repeatable perfor-
mance. M/A-COM’s surface mount manufacturing tech-
niques together with automatic assembly and electrical
testing ensure a high degree of electrical and mechanical
repeatability at low cost and in high volume. Manufacturing
is carried out in an ISO 9000 qualified facility.
Electrical Specifications1, TA = +25°C, VCC = +5V (unless otherwise stated)
Parameter
Test Conditions
Units
Min.
Typ.
Max.
Frequency Range
Tuning Voltage (VT)2
RF Output Power3
Supply Voltage (VCC)4
Supply Current (ICC)
Phase Noise5
Average Tuning Sensitivity6
—
—
1930 - 1990 MHz
—
—
SSB at 100 kHz offset from carrier
1930 - 1990 MHz
MHz
V
dBm
V
mA
dBc/Hz
MHz/V
1930
+0.5
-3.0
+4.75
—
—
—
—
—
—
+5.00
13
-118
31
1990
+4.5
+3.0
+5.25
15
-115
—
Tuning Linearity
Harmonic Outputs7
1930 - 1990 MHz
—
Ratio
—
dBc
—
1.2
2.0
-22
-15
Frequency Pushing
Frequency Pulling
VCC 4.75V to 5.25V
1.5:1 VSWR load, all phases
MHz/V
—
1.7
3.0
MHz
—
4.5
5.5
Frequency Drift
-20°C to +70°C
MHz/°C
—
-0.16
—
Tune Input Capacitance
—
1. All specifications apply with a 50 ohm load impedance.
2. Tuning voltages shown are the minimum and maximum voltages
required to tune the frequency range including temperature effects -
20°C to +70°C. Devices will oscillate normally with tuning voltages
from 0V to +10V.
3. Output power window includes unit to unit variation, temperature
effects -20°C to +70°C and frequency flatness (typically 0.5 dB at
any constant temperature).
pF
—
—
50
4. Devices may be operated at lower typical supply voltage with
reduced performance.
5. For typical phase noise at other offsets see phase noise curve.
6. Defined as (1990-1930) / (VT 1990 - VT 1930) MHz/V.
7. Non harmonic spurious less than -70dBc.
V4.00
www.macom.com
M/A-COM Division of AMP Incorporated s North America: Tel. (800) 366-2266, Fax (800) 618-8883 s Asia/Pacific: Tel.+85 2 2111 8088,
Fax +85 2 2111 8087 s Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
AMP and Connecting at a Higher Level are trademarks.
Specifications subject to change without notice.
Share Link: 