MSM6896GS-BK データシートの表示（PDF） - Oki Electric Industry

部品番号

コンポーネント説明

メーカー

MSM6896GS-BK

Multi-Function PCM CODEC

Oki Electric Industry 

¡ Semiconductor

MSM6895/6896

SA0, SA1

Sounder (ringing tone) driving outputs.

The output signal on SA1 is inverted against the signal on SA0. The sounder circuit can be easily

configured by connecting a piezo-sounder between SA0 and SA1. Through processor control, the

ringing tone volume is selectable from four levels and one of six tone combinations is selectable.

Initially, the ringing tone volume is set at a maximum and the tone combination is set externally.

If these pins are used with no-load, tone volume cannot be controlled.

When tone volume control is required, a load resistor must be connected between SA0 and SA1.

RMI, RMO0, RMO1

Receive main amplifier input and outputs.

RMI is the main amplifier input and RMO0 and RMO1 are the main amplifier outputs. The

output signal on RMO1 is inverted against RMO0, so the earphone of a piezo electric-type

handset is directly connected between RMO0 and RMO1. The RMI input pin is connected to the

receive preamplifier output pin (RPO).

If the adjusting of receive path frequency characteristics is required, insert the following circuit

for adjustment. During initial setting, the speech path from RMI to RMO0 and RMO1 is

disconnected and the output of RMO0 and RMO1 is at the VSG level (VA/2). The speech path

is provided by processor control.

A circuit example for adjustment of frequency characteristics

RPO

R1

RMI VSG

C2

C1

R2

SPO

Output of preamplifier for speaker.

Since the driving capability is 2.4 VPP for the load of 20 kW, SPO can not directly drive a speaker.

During initial setting, SPO is in a non-signal state (VSG level), and a speech signal, RTONE0,

RTONE1, FTONE, hold acknowledge tone, and PB signal acknowledge tone are output through

processor control.

7/43

Share Link: