Electrical Characteristics: (TA = +25°C, VCC = 5V and VIK = 0V, Note 1, unless otherwise specified)
Parameter
Symbol
Test Conditions
Min Typ Max Unit
Input Voltage − High Logic State
VIH Three−State Control
2.0
Input Voltage − Low Logic State
VIL Three−State Control
−
Differential Input Threshold Voltage VTH(D) −7V ≤ VIC ≤ +7V,
VIH = 2V, Note 2
IO = −0.4mA, −
VOH ≥ 2.7V
IO = 8.8mA,
−
VOH ≥ 0.5V
Input Bias Current
IIB(D) VCC = 0V or 5.25V
VI = −10V
−
Other Inputs at 0V
VI = −3V
−
VI = +3V
−
VI = +10V
−
Input Balance and Output Level
VOH −7V ≤ VIC ≤ 7.0,
VIH = 2V, Note 3
IO = −0.4mA, 2.7
VID =+0.4mA
VOL
IO = 8.0mA,
−
VID = −0.4V
Output Third State Leakage Current IOZ V(ID) = +3.0V, VIL = 0.8V, VOL = 0.5V
−
V(ID) = −3.0V, VIL = 0.8V, VOH = 2.7
−
Output Short−Circuit Current
IOS VI(D) = 3.0V, VIH = 2.0V, VO = 0V, Note 4 −15
Input Current − Low Logic State
lIL Three−State Control, VIL = 0.5V
−
Input Current − High Logic State
lIH Three−State Control, VIH = 2.7V
−
Three−State Control, VIH = 5.25V
−
Input Clamp Diode Voltage
VIK Three−State Control, lIk = −10mA
−
Power Supply Current
ICC VIL = 2.0V
−
−
−
V
− 0.8 V
− 0.2 V
− −0.2 V
− −3.25 mA
− −1.50 mA
− +1.50 mA
− +3.25 mA
−
−
V
− 0.5 V
− −40 µA
− 40 µA
− −100 mA
− −100 µA
− 20 µA
− 100 µA
− −1.5 V
− 85 mA
Note 1. All currents into device pins are shown as positive, out of device pins are negative. All voltages
referenced to ground unless otherwise noted.
Note 2. Differential input threshold voltage and guaranteed output levels are done simultaneously
for worst case.
Note 3. Refer to EIA−422/3 for exact conditions. Input balance and guaranteed output levels are
done simultaneously for worst case.
Note 4. Only one output at a time should be shorted.