AM29F800BT-120EIB データシートの表示（PDF） - Advanced Micro Devices

部品番号

コンポーネント説明

メーカー

AM29F800BT-120EIB

8 Megabit (1 M x 8-Bit/512 K x 16-Bit) CMOS 5.0 Volt-only, Boot Sector Flash Memory—Die Revision 1

Advanced Micro Devices 

PRELIMINARY

Table 4. Am29F800B Autoselect Codes (High Voltage Method)

Description

A18 A11

A8

A5

DQ8

to to

to

to

to

Mode CE# OE# WE# A12 A10 A9 A7 A6 A2 A1 A0 DQ15

DQ7

to

DQ0

Manufacturer ID: AMD

L

L

H X X VID X L X L L

X

01h

Device ID:

Word L

L

H

22h

D6h

Am29F800B

X X VID X L X L H

(Top Boot Block)

Byte L

L

H

X

D6h

Device ID:

Word L

L

H

22h

58h

Am29F800B

X X VID X L X L H

(Bottom Boot Block) Byte L

L

H

X

58h

Sector Protection Verification L

L

H SA X VID X L X H L

X

01h

(protected)

X

00h

(unprotected)

L = Logic Low = VIL, H = Logic High = VIH, SA = Sector Address, X = Don’t care.

Sector Protection/Unprotection

The hardware sector protection feature disables both

program and erase operations in any sector. The

hardware sector unprotection feature re-enables both

program and erase operations in previously pro-

tected sectors.

Sector protection/unprotection must be implemented

using programming equipment. The procedure re-

quires a high voltage (VID) on address pin A9 and the

control pins. Details on this method are provided in a

supplement, publication number 20374. Contact an

AMD representative to obtain a copy of the appropriate

document.

The device is shipped with all sectors unprotected.

AMD offers the option of programming and protecting

sectors at its factory prior to shipping the device

through AMD’s ExpressFlash™ Service. Contact an

AMD representative for details.

It is possible to determine whether a sector is protected

or unprotected. See “Autoselect Mode” for details.

Temporary Sector Unprotect

This feature allows temporary unprotection of previ-

ously protected sectors to change data in-system.

The Sector Unprotect mode is activated by setting the

RESET# pin to VID. During this mode, formerly pro-

tected sectors can be programmed or erased by se-

lecting the sector addresses. Once VID is removed

from the RESET# pin, all the previously protected

sectors are protected again. Figure 1 shows the algo-

rithm, and the Temporary Sector Unprotect diagram

shows the timing waveforms, for this feature.

START

RESET# = VID

(Note 1)

Perform Erase or

Program Operations

RESET# = VIH

Temporary Sector

Unprotect

Completed (Note 2)

Notes:

21504C-5

1. All protected sectors unprotected.

2. All previously protected sectors are protected once

again.

Figure 1. Temporary Sector Unprotect Operation

Am29F800B

11

Share Link: