PCA9552 データシートの表示（PDF） - Philips Electronics

部品番号

コンポーネント説明

メーカー

PCA9552

16-bit I2C LED driver with programmable blink rates

Philips Electronics 

Philips Semiconductors

16-bit I2C LED driver with programmable blink rates

Product data sheet

PCA9552

APPLICATION DATA

5V

5V

SDA

SCL

I2C/SMBus MASTER

10 kΩ (3×)

SDA

SCL

RESET

A2

A1

A0

VSS

VDD LED0

LED1

LED2

LED3

LED4

LED5

LED6

LED7

LED8

LED9

LED10

LED11

LED12

LED13

LED14

LED15

PCA9552

Note: LED0 to LED12 are used as LED drivers

LED13 to LED15 are used as regular GPIOs.

Figure 13. Typical application

GPIOs

SW00930

Minimizing IDD when the I/O is used to control LEDs

When the I/Os are used to control LEDs, they are normally connected to VDD through a resistor as shown in Figure 13. Since the LED acts as a

diode, when the LED is off the I/O VIN is about 1.2 V less than VDD. The supply current, IDD, increases as VIN becomes lower than VDD and is

specified as ∆IDD in the DC characteristics table.

Designs needing to minimize current consumption, such as battery power applications, should consider maintaining the I/O pins greater than or

equal to VDD when the LED is off. Figure 14 shows a high value resistor in parallel with the LED. Figure 15 shows VDD less than the LED supply

voltage by at least 1.2 V. Both of these methods maintain the I/O VIN at or above VDD and prevents additional supply current consumption when

the LED is off.

VDD

3.3 V

5V

VDD

LEDx

LED

100 kΩ

SW02086

Figure 14. High value resistor in parallel with the LED

VDD

LEDx

LED

SW02087

Figure 15. Device supplied by a lower voltage

2004 Oct 01

10

Share Link: