REF-01 データシートの表示（PDF） - Linear Technology
部品番号
コンポーネント説明
メーカー
REF-01 Datasheet PDF : 8 Pages
| |||
ELECTRICAL CHARACTERISTICS
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Line and load regulation specifications include the effect of self
heating.
Note 3: Limit current in or out of Pin 3 to 50nA and capacitance on Pin 3
to 30pF.
Note 4: ΔV is defined as the absolute difference between the maximum
output voltage and the minimum output voltage over the specified
temperature range expressed as a percentage of nominal output.
ΔV = VMAX – VMIN •100
VOUT
REF-01/REF-02
Note 5: ΔV specification applies trimmed or untrimmed.
Note 6: TC is defined as ΔV divided by the temperature range, i.e.,
TC =
ΔV
TMAX – TMIN
Note 7: 0.1Hz to 10Hz noise cannot be 100% tested on modern high speed
test equipment, so Linear Technology does not put a guaranteed maximum
specification on this parameter for standard units. 100% bench testing of
0.1Hz to 10Hz noise is available on special request. To ensure low output
noise, Linear Technology does 100% test 10Hz to 1kHz noise. Consult
factory for details.
PACKAGE DESCRIPTION
H Package
8-Lead TO-5 Metal Can (.230 Inch PCD)
(Reference LTC DWG # 05-08-1321)
.040
(1.016)
MAX
SEATING
PLANE
.010 – .045*
(0.254 – 1.143)
.335 – .370
(8.509 – 9.398)
DIA
.305 – .335
(7.747 – 8.509)
.050
(1.270)
MAX
.165 – .185
(4.191 – 4.699)
GAUGE
PLANE
REFERENCE
PLANE
.500 – .750
(12.700 – 19.050)
.016 – .021**
(0.406 – 0.533)
45°
.028 – .034
(0.711 – 0.864)
.027 – .045
(0.686 – 1.143)
PIN 1
.230
(5.842)
TYP
.110 – .160
(2.794 – 4.064)
INSULATING
STANDOFF
*LEAD DIAMETER IS UNCONTROLLED BETWEEN THE REFERENCE PLANE
AND THE SEATING PLANE
.016 – .024
**FOR SOLDER DIP LEAD FINISH, LEAD DIAMETER IS (0.406 – 0.610) H8 (TO-5) 0.230 PCD 0204
ref012fd
5
Share Link: 