RF100 データシートの表示（PDF） - Teledyne Technologies Incorporated
部品番号
コンポーネント説明
メーカー
RF100
Teledyne Technologies Incorporated
RF100 Datasheet PDF : 4 Pages
| |||
SERIES RF100 and RF103
TYPICAL RF CHARACTERISTICS (Notes 1, 2 and 3)
INSERTION LOSS AND VSWR CHARACTERISTICS RF100 and RF103 NORMALLY CLOSED CONTACTS
0.0
2.0
-0.2
INSERTION LOSS
1.9
-0.4
1.8
-0.6
1.7
-0.8
1.6
-1.0
1.5
1.2
1.4
-1.4
1.3
-1.6
1.2
-1.8
VSWR
1.1
-2.0
1.0
.0003
1.0
2.0
3.0
4.0
5.0
6.0
FREQUENCY (GHz)
INSERTION LOSS AND VSWR CHARACTERISTICS RF100 and RF103 NORMALLY OPEN CONTACT
0.0
2.0
-0.2
INSERTION LOSS
1.9
-0.4
1.8
-0.6
1.7
-0.8
1.6
-1.0
1.5
1.2
1.4
-1.4
1.3
-1.6
1.2
-1.8
VSWR
1.1
-2.0
1.0
.0003
1.0
2.0
3.0
4.0
5.0
6.0
FREQUENCY (GHz)
ISOLATION CHARACTERISTICS RF100 AND RF103 RELAYS
ISOLATION POLE TO POLE (NOTE 4)
0
0
-10
-10
-20
-20
-30
-30
-40
-40
-50
-50
-60
.0003
1.0
2.0
3.0
4.0
5.0
6.0
FREQUENCY (GHz)
-60
.0003
ISOLATION CONTACT TO CONTACT (NOTE 5)
1.0
2.0
3.0
4.0
5.0
6.0
FREQUENCY (GHz)
RF Notes:
1. Test conditions: a. Fixture: .031” copper clad, reinforced PTFE, RT/duroid® 6002 with SMA connectors. (RT/duroid® is a registered
trademark of Rogers Corporation).
b. Relay header is in contact with but not soldered to ground plane or connected to ground via ground pin.
c. Test performed at room ambient temperature.
d. Terminals not tested were terminated with 50 ohm load.
e. Contact signal level: 20 dBm.
2. Data presented herein represents typical characteristics and is not intended for use as specification limits.
3. Data is per pole.
4. Data is the average from readings taken when the relay is de-energized and energized. Measurement points are from pins 1 and 3 to
pins 5 and 7 (de-energized) and pins 1 and 2 to pins 6 and 7 (energized).
5.Data is the average from readings taken when the relay is de-energized and energized. Measurement points are from pins 1, 3 to 2 and
pins 5,7 to 6 (de-energized) and pins 1,2 to 3 and pins 6,7 to 5 (energized).
Share Link: