S202S12F データシートの表示（PDF） - Sharp Electronics
部品番号
コンポーネント説明
メーカー
S202S12F
Sharp Electronics
S202S12F Datasheet PDF : 13 Pages
| |||
S102S12 Series
S202S12 Series
In case the optional heat sink is screwed up, please solder after screwed.
In case of the lead frame bending, please keep the following minimum distance and avoid any mechanical
stress between the base of terminals and the molding resin.
4.4mm MIN.
Some of AC electromagnetic counters or solenoids have built-in rectifier such as the diode.
In this case, please use the device carefully since the load current waveform becomes similar with
rectangular waveform and this results may not make a device turn off.
● Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
● Standard Circuit
R1
+VCC
D1
V1
Tr1
S102S12
S202S12
3
1
SSR
4
2
Load
AC Line
✩ For additional design assistance, please review our corresponding Optoelectronic Application Notes.
Sheet No.: D4-A02901EN
9
Share Link: