Philips Semiconductors
CMOS dual universal serial communications controller
(CDUSCC)
Product specification
SC26C562
• Odd or even parity, no parity, or force parity
• Up to two stop bits programmable in 1/16-bit increments
• 1X or 16X Rx and Tx clock factors
• Parity, overrun and framing error detection
• False start bit detection
• Break generation with handshake for counting break characters
• Detection of start and end of received break
• Character compare with optional interrupt on match
• Transmit and receive up to 10Mbps at 1x or 1Mbps at 16x data
rates
Bit-Oriented Protocol
• Character length: 5 to 8 bits
• Detection and transmission of residual character: 0–7 bits
• Automatic switch to programmed character length for I field
• Zero insertion and deletion
• Optional opening PAD transmission
• Detection and generation of FLAG, ABORT, and IDLE bit patterns
• Transmit 7 or 8 bit ABORT
• Detection and generation of shared (single) FLAG between
frames
• Detection of overlapping (shared zero) FLAGs
• Idle in MARK or FLAGs
• Secondary address recognition including group and global
address
• Single- or dual-octet secondary address
• Extended address and control fields
• Short frame rejection for receiver
• Detection and notification of received end of message
• CRC generation and checking
• SDLC loop mode capability
Character-Oriented Protocols
• Character length: 5 to 8 bits
• Odd or even parity, no parity, or force parity
• LRC or CRC generation and checking
• Optional opening PAD transmission
• One or two SYN characters
• External sync capability
• SYN detection and optional stripping
• SYN or MARK line-fill or underrun
• Idle in MARK or SYNs
• Parity, FCS, overrun and underrun error detection
• Optional SYNC exclusion from FCS
• BISYNC features
– EBCDIC or ASCII header, text and control messages
– SYN, DLE stripping
– EOM (end of message) detection and transmission
– Auto transparency mode switching
– Auto hunt after receipt of EOM sequence (with closing PAD
check after EOT or NAK)
– Control character sequence detection for both transparent and
normal text
– Parity generation for data and LRC characters
ORDERING INFORMATION
DESCRIPTION
48-Pin Plastic Dual In-Line Package (DIP)
52-Pin Plastic Leaded Chip Carrier (PLCC) Package
COMMERCIAL
Serial Data Rate =
10Mbps Maximum
SC26C562C1N
SC26C562C1A
INDUSTRIAL
Serial Data Rate =
8Mbps Maximum
Not available
SC26C562A8A
DWG #
SOT240-1
SOT238-3
ABSOLUTE MAXIMUM RATINGS1
SYMBOL
TA
TSTG
VCC
VS
PARAMETER
Operating ambient temperature2
Storage temperature
Voltage from VCC to GND3
Voltage from any pin to ground3
COMMERCIAL
0 to +70
-65 to +150
–0.5 to +7.0
–0.5 to VCC +0.5
RATING
INDUSTRIAL
-40 to +85
-65 to +150
–0.5 to +7.0
–0.5 to VCC +0.5
UNIT
°C
°C
V
V
1998 Sep 04
3