MX29F001TTC-12 データシートの表示（PDF） - Macronix International
部品番号
コンポーネント説明
メーカー
MX29F001TTC-12 Datasheet PDF : 43 Pages
| |||
MX29F001T/B
Q5
Exceeded Timing Limits
Q5 will indicate if the program or erase time has exceeded
the specified limits(internal pulse count). Under these
conditions Q5 will produce a "1". This time-out condition
indicates that the program or erase cycle was not
successfully completed. Data Polling and Toggle Bit are
the only operating functions of the device under this
condition.
If this time-out condition occurs during sector erase
operation, it is specifies that a particular sector is bad and
it may not be reused. However, other sectors are still
functional and may be used for the program or erase
operation. The device must be reset to use other sectors.
Write the Reset command sequence to the device, and
then execute program or erase command sequence.
This allows the system to continue to use the other active
sectors in the device.
If this time-out condition occures during the chip erase
operation, it specifies that the entire chip is bad or
combination of sectors are bad.
If this time-out condition occurs during the byte
programming operation, it specifies that the entire sector
containing that byte is bad and this sector maynot be
reused, (other sectors are still functional and can be
reused).
The time-out condition may also appear if a user tries to
program a non blank location without erasing. In this
case the device locks out and never completes the
Automatic Algorithm operation. Hence, the system never
reads a valid data on Q7 bit and Q6 never stops toggling.
Once the Device has exceeded timing limits, the Q5 bit
will indicate a "1". Please note that this is not a device
failure condition since the device was incorrectly used.
Q3
Sector Erase Timer
After the completion of the initial sector erase command
sequence th sector erase time-out will begin. Q3 will
remain low until the time-out is complete. Data Polling
and Toggle Bit are valid after the initial sector erase
command sequence.
If Data Polling or the Toggle Bit indicates the device has
been written with a valid erase command, Q3 may be
used to determine if the sector erase timer window is still
open. If Q3 is high ("1") the internally controlled erase
cycle has begun; attempts to write subsequent commands
to the device will be ignored until the erase operation is
completed as indicated by Data Polling or Toggle Bit. If
Q3 is low ("0"), the device will accept additional sector
erase commands. To insure the command has been
accepted, the system software should check the status of
Q3 prior to and following each subsequent sector erase
command. If Q3 were high on the second status check,
the command may not have been accepted.
DATA PROTECTION
The MX29F001T/B is designed to offer protection against
accidental erasure or programming caused by spurious
system level signals that may exist during power transition.
During power up the device automatically resets the state
machine in the Read mode. In addition, with its control
register architecture, alteration of the memory contents
only occurs after successful completion of specific
command sequences. The device also incorporates
several features to prevent inadvertent write cycles
resulting from VCC power-up and power-down transition
or system noise.
P/N: PM0515
REV. 2.1, JUN. 14, 2001
11
Share Link: 