SP6200EM5-2.85/TR データシートの表示（PDF） - Signal Processing Technologies

部品番号

コンポーネント説明

メーカー

SP6200EM5-2.85/TR

Micropower, 100mA and 200mA CMOS LDO Regulators

Signal Processing Technologies 

ELECTRICAL CHARACTERISTICS: Continued

VIN = VOUT +1V, VO = 5V for ADJ, IL = 100µA, CIN = 1.0µF, COUT = 1.0µF, TJ = 25°C , unless otherwise specified. The ♦ denotes the

specifications which apply over the full operating temperature range, unless otherwise specified.

PARAMETER

Thermal Regulation,

Note 8, (∆VO/∆PD)

Output Noise, (e no)

ENABLE INPUT

Enable Input Logic-Low Voltage,

(VIL)

Enable Input Logic-High Voltage,

(VIH)

Enable Input Current, (IIL), (IIH)

Reset Not Output

MIN TYP MAX UNITS

0.05

%/W

150

µVrms

0.4

V

1.6

V

0.01 1

µA

0.01 1

µA

-2

-4

-6

%

♦ CONDITIONS

IL = 50mA, CL = 1µF

0.1µF from VOUT to Adj.

10Hz to 100kHz

♦ Regulator Shutdown

♦ Regulator Enabled

♦ VIL < 0.4V

♦ VIH > 2.0V

Threshold

Note 1. Exceeding the absolute maximum rating may damage the device.

Note 2. The device is not guaranteed to function outside its operating rating.

Note

3.

The

maximum

allowable

power

dissipation

at

any

T

A

(ambient

temperature)

is

P

D

(MAX)

=

(T

J

(MAX)

–

T)

A

/

θϑA.

Exceeding the maximum allowable power dissipation will result in excessive die temperature, and the regulator will

go into thermal shutdown. The θJA of the SP6200/6201 (all versions) is 90°C/W for the SOT-23-5 and 59°C/W for

the DFN package on a standard 4 layer board (see “Thermal Considerations” section for further details).

Note 4. Output voltage temperature coefficient is defined as the worst case voltage change divided by the total

temperature range.

Note 5. Load Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are

tested for load regulation in the load range; from 0.1mA to 100mA, SP6200; from 0.1mA to 200mA, SP6201. Changes

in output voltage due to heating effects are covered by the thermal regulation specification. Not applicable to output

voltages less than 2.5V.

Note 6. Dropout Voltage is defined as the input to output differential at which the output voltage drops 2% below

its nominal value measured at 1V differential. Not applicable to output voltages less than 2.7V.

Note 7. Ground pin current is the regulator quiescent current. The total current drawn from the supply is the sum

of the load current plus the ground pin current.

Note 8. Thermal regulation is defined as the change in output voltage at a time ”t” after a change in power dissipation

is applied, excluding load or line regulation effects. Specifications are for a 100mA load pulse at VIN = 6V for t = 10ms.

Date:5/25/04

SP6200/6201 100/200mA CMOS LDO Regulator

3

© Copyright 2004 Sipex Corporation

Share Link: