SP8024 データシートの表示（PDF） - Signal Processing Technologies

部品番号

コンポーネント説明

メーカー

SP8024

200V/µs Integrated APC Amplifier with Gain Adjust & Differential Output

Signal Processing Technologies 

Layout and Routing Considerations

Special care must be taken when designing the

Flex or PCB for this part. The output peak

current requirement is in the order of 12.5mA

when driving 50pF of capacitive load with a

slew rate of 200V/s Therefore care must be

taken to provide low inductance, low resistance

paths for power and ground and output traces.

Supply coupling is also very important. Good

supply decoupling is important to ensure the

high frequency performance of the system by

eliminating supply lead inductance effects. The

decoupling capacitor C1 should be as close to

the part as possible. This capacitor should be

0.1µF ceramic. C2 is optional to improve

decoupling and is recommended to be 1µF tan-

talum. The layout of the PCB is pictured here.

Note the wide and short traces on the supply

lines.

The traces for the gain resistors R1 and R2 are

kept as short as possible to avoid excessive

parasitics. Any parasitics on these nodes will

limit the performance of the system. R1 and R2

are subminiature potentiometers in the applica-

tion. This is a single layer board done on FR4

material.

In order to minimize coupling capacitance into

the gain setting resistor nodes, it is also critical

that VOUT+ and VOUT- are routed away from the

traces associated with the gain-setting resistors.

Top

Figure 2. Test and Evaluation PCB Layout for COB 8 Lead Package

Bottom

Rev. 6/02/03

SP8024, 25, 26 200V/µs Integrated APC Amplifier

5

© Copyright 2003 Sipex Corporation

Share Link: