SSD1815T1R データシートの表示（PDF） - Solomon Systech

部品番号

コンポーネント説明

メーカー

SSD1815T1R

LCD Segment / Common Driver with Controller for Character Display System

Solomon Systech  

OPERATION OF LIQUID CRYSTAL DISPLAY DRIVER

Description of Block Diagram Module

Command Decoder and Command Interface

This module determines whether the input data is interpreted as

data or command. Data is directed to this module based upon the

input of the D/C pin. If D/C is high, data is written to Graphic Display

Data RAM (GDDRAM). If D/C is low, the input at D7-D0 is interpreted

as a Command and it will be decoded and be written to the corre-

sponding command register.

MPU Parallel 6800-series Interface

The parallel interface consists of 8 bi-directional data pins (D7-D0),

R/W(WR), D/C, E(RD), CS1 and CS2. R/W(WR) input High indicates

a read operation from the Graphic Display Data RAM (GDDRAM) or

the status register. R/W(WR) input Low indicates a write operation to

Display Data RAM or Internal Command Registers depending on the

status of D/C input. The E(RD) input serves as data latch signal

(clock) when high provided that CS1 and CS2 are low and high

respectively. Refer to Figure 9 for Parallel Interface Timing Diagram

of 6800-series microprocessors.

In order to match the operating frequency of display RAM with that

of the microprocessor, some pipeline processing is internally per-

formed which requires the insertion of a dummy read before the first

actual display data read. This is shown in Figure 3 below.

MPU Parallel 8080-series interface

The parallel interface consists of 8 bi-directional data pins (D7-D0),

E(RD), R/W(WR), D/C, CS1 and CS2. E(RD) input serves as data

read latch signal (clock) when low provided that CS1 and CS2 are

low and high respectively. Whether it is display data or status regis-

ter read is controlled by D/C. R/W(WR) input serves as data write

latch signal(clock) when high provided that CS1 and CS2 are low

and high respectively. Whether it is display data or command regis-

ter write is controlled by D/C. Refer to Figure 10 for Parallel Interface

Timing Diagram of 8080-series microprocessor.

Similar to 6800-series interface, a dummy read is also required

before the first actual display data read.

MPU Serial interface

The serial interface consists of serial clock SCK (D6), serial data

SDA (D7), D/C, CS1 and CS2. SDA is shifted into a 8-bit shift register

on every rising edge of SCL in the order of D7, D6,... D0. D/C is sam-

pled on every eighth clock to determine whether the data byte in the

shift register is written to the Display Data RAM or command register

at the same clock.

R/W(WR)

E(RD)

data bus

N

write column address

dummy read

n

data read1

n+1

data read 2

Figure 3 - Display data read with the insertion of dummy read

n+2

data read 3

Oscillator Circuit

This module is an On-Chip low power RC oscillator circuitry

(Figure 4). The oscillator generates the clock for the DC-DC volt-

age converter. This clock is also used in the Display Timing Gen-

erator.

enable

Oscillation Circuit

Oscillator enable

enable

Buffer (CL)

SOLOMON

OSC1

Internal pwell resistor

OSC2

Figure 4 - Oscillator Circuitry

REV 1.5

03/2000

SSD1815

9

Share Link: