ST485EB - ST485EC - ST485EX
Electrical characteristics
Table 7.
Symbol
DC electrical characteristics (continued) (VCC = 5 V ± 5 %, TA = TMIN to TMAX, unless
otherwise specified. Typical values are referred to TA = 25 °C)
Parameter
Test conditions (1)
Min. Typ. Max. Unit
IOSD2
Driver short-circuit current,
VO=Low
VO = -7 to 12 V (3)
35
250 mA
IOSR Receiver short-circuit current VO = 0 V to VCC
7
95 mA
1. All currents into device pins are positive; all out of device pins are negative; all voltages are referenced to device ground
unless specified.
2. Supply current specification is valid for loaded transmitters when VDE = 0 V
3. Applies to peak current. See typical Operating Characteristics.
Table 8.
Symbol
Driver switching characteristics (VCC = 5 V ± 5 %, TA = TMIN to TMAX, unless otherwise
specified. Typical values are referred to TA = 25 °C)
Parameter
Test conditions (1)
Min. Typ. Max. Unit
tPLH
tPHL
tSK
tTLH
tTHL
tPZH
tPZL
tPLZ
tPHZ
Propagation delay input to RDIFF = 54 Ω, CL1 = CL2 = 100 pF
output
(See Figure 4 and Figure 6)
Output skew to output
RDIFF = 54 Ω, CL1 = CL2 = 100 pF
(See Figure 4 and Figure 6)
Rise or fall time
RDIFF = 54 Ω, CL1 = CL2 = 100 pF
(See Figure 4 and Figure 6)
Output enable time
CL = 100 pF, S2 = Closed
(See Figure 5 and Figure 7)
Output enable time
CL = 100 pF, S1 = Closed
(See Figure 5 and Figure 7)
Output disable time
CL = 15 pF, S1 = Closed
(See Figure 5 and Figure 7)
Output disable time
CL = 15 pF, S2 = Closed
(See Figure 5 and Figure 7)
25 45 ns
2
5
ns
15 40 ns
35 50 ns
25 40 ns
25 40 ns
35 50 ns
1. All currents into device pins are positive; all out of device pins are negative; all voltages are referenced to device ground
unless specified.
7/18