M61301E データシートの表示（PDF） - MITSUBISHI ELECTRIC
部品番号
コンポーネント説明
メーカー
M61301E Datasheet PDF : 25 Pages
| |||
MITSUBISHI< LINEAR IC >
Note1)
M61301SP
BUS CONTROLLED 3CH VIDEO PRE-AMP FOR CRT DISPLAY MONITOR
Measuring conditions are as listed in supplementary Table. Measured with a current
meter at test point IA.
Note2) Measuring conditions are as listed in supplementary Table. Measured with a current
meter at test point IB.
Note3)
Decrease V1 gradually, and measure the voltage when the bottom of waveform output is
distorted. The voltage is called VCL.
Next, increase V1 gradually, and measure the voltage when the top of waveform output is
distorted. The voltage is called VOH.
Voltagr Vomax is calculated by the equation below:
Vomax = VOH - VOL
(V)
VOH
5.0
Waveform output
Note4)
VOL
0.0
Increase the input signal(SG2) amplitude gradually, starting from 700mVp-p. Measure the
amplitude of the input signal when the output signal starts becoming distorted.
Note5)
Input SG1, and read the amplitude output at OUT(24,28,31). The amplitude is called
VOUT(24,28,31).Maximum gain GV is calculated by the equation below:
VOUT
GV=20 LOG
(dB)
0.7
Note6) Relative maximum gain GV is calculated by the equation below:
GV=VOUT(24)/VOUT(18), VOUT(28)/VOUT(31), VOUT(31)/VOUT(24)
Note7)
Measuring the amplitude output at OUT(24,28,31). The measured value is called
VOUT(24,28,31).
Main contrast conrol characteristics VC1 is calculated by the equation below:
VOUT
VC1=20 LOG
(dB)
0.7
Note8) Relative characteristics VC1 is calculated by the equation below:
VC1=VOUT(24)/VOUT(28) , VOUT(28)/VOUT(31) , VOUT(31)/VOUT(24)
Note9) Measuring condition and procedure are the same as described in Note7.
Note10) Measuring condition and procedure are the same as described in Note8.
Note11) Measuring condition and procedure are the same as described in Note7.
Note12) Measuring condition and procedure are the same as described in Note8.
MITSUBISHI
11
25
Share Link: 