TMP87P809NG データシートの表示（PDF） - Toshiba
部品番号
コンポーネント説明
メーカー
TMP87P809NG Datasheet PDF : 19 Pages
| |||
TMP87P809
TOSHIBA Microcontrollers
870 Family
(TMP87C409BN) (TMP87C409BM) (TMP87C809BN) (TMP87C809BM) （TMP87P809）
Datasheet Modifications: I2C Bus Mode Control
The following problem is included in the explanation of the I2C bus function of this data sheet.
It will guide the correction as follows. Please read it for the explanation of this data sheet as follows.
Section: “I2C Bus Mode Control”
▪ In the explanation of the Serial Bus Interface Control Register 1
1. Delete the setting examples where the serial clock frequency exceeds 100 kHz.
2. Add the following note.
SCK Serial clock selection
000 : Reserved
001 : Reserved
010 : 58.8
011 : 30.3
100 : 15.4
101 : 7.75
110 : 3.89
111 : reserved
(Note)
(Note)
kHz
kHz
kHz
kHz
kHz
at fc = 8MHz (Output on SCL
pin)
Write-
only
Note: This I2C bus circuit does not support the Fast mode. It supports the Standard mode only. Although
the I2C bus circuit itself allows the setting of a baud rate over 100 kbps, the compliance with the I2C
specification is not guaranteed in that case.
▪ In “(3) Serial clock”
1. Add the following sentence about the communication baud rate.
a. Clock source
The SCK (bits 2 to 0 in the SBICR1) is used to select a maximum transfer frequency
outputed on the SCL pin in the master mode. Set a communication baud rate that meets
the I2C bus specification, such as the shortest pulse width of tLOW, based on the equations
shown below.
In both master mode and slave mode, a pulse width of at least 4 machine cycles is require
for both “H” and “L” levels.
tLOW = 2n/fc
tHIGH = 2n/fc + 8/fc
fscl = 1/(tLow + tHIGH)
2008-02-08
Share Link: 