TNY253(2001) データシートの表示（PDF） - Power Integrations, Inc

部品番号

コンポーネント説明

メーカー

TNY253
(Rev.:2001)

Energy Efficient, Low Power Off-line Switchers

Power Integrations, Inc 

TNY253/254/255

BYPASS

50 µA

OSCILLATOR

CLOCK

DCMAX

REGULATOR

5.8 V

5.8 V

5.1 V

UNDER-VOLTAGE

+

-

THERMAL

SHUTDOWN

DRAIN

VILIMIT

S

Q

ENABLE

1.5 V + VTH

R

Q

LEADING

EDGE

BLANKING

SOURCE

Figure 2. Functional Block Diagram.

Pin Functional Description

DRAIN (D) Pin:

Power MOSFET drain connection. Provides internal operating

current for both start-up and steady-state operation.

BYPASS (BP) Pin:

Connection point for an external bypass capacitor for the

internally generated 5.8V supply. Bypass pin is not intended

for sourcing supply current to external circuitry.

ENABLE (EN) Pin:

The power MOSFET switching can be terminated by pulling

this pin low. The I-V characteristic of this pin is equivalent to

a voltage source of approximately 1.5V with a source current

clamp of 50 µA.

SOURCE (S) Pin:

Power MOSFET source connection. Primary return.

TinySwitch Functional Description

TinySwitch is intended for low power off-line applications. It

combines a high voltage power MOSFET switch with a power

supply controller in one device. Unlike a conventional PWM

(Pulse Width Modulator) controller, the TinySwitch uses a

simple ON/OFF control to regulate the output voltage.

The TinySwitch controller consists of an Oscillator, Enable

(Sense and Logic) circuit, 5.8V Regulator, Under-Voltage

PI-2197-061898

BYPASS 1

8 SOURCE

SOURCE 2

7 SOURCE

SOURCE 3

6 SOURCE

ENABLE 4

5 DRAIN

P Package (DIP-8)

G Package (SMD-8)

Figure 3. Pin Configuration.

PI-2199-031501

circuit, Hysteretic Over Temperature Protection, Current Limit

circuit, Leading Edge Blanking, and a 700V power MOSFET.

Figure 2 shows a functional block diagram with the most

important features.

Oscillator

The oscillator frequency is internally set at 44 kHz (130 kHz for

the TNY255). The two signals of interest are the Maximum

Duty Cycle signal (DMAX) which runs at typically 67% duty

cycle and the Clock signal that indicates the beginning of each

cycle. When cycles are skipped (see below), the oscillator

frequency doubles (except for TNY255 which remains at

130kHz). This increases the sampling rate at the ENABLE pin

for faster loop response.

Enable (Sense and Logic)

The ENABLE pin circuit has a source follower input stage set

at 1.5V. The input current is clamped by a current source set

at 50 µA with 10 µA hysteresis. The output of the enable sense

2

C

7/01

Share Link: