UAA3535HL データシートの表示（PDF） - Philips Electronics
部品番号
コンポーネント説明
メーカー
UAA3535HL Datasheet PDF : 24 Pages
| |||
Philips Semiconductors
Low power GSM/DCS/PCS multi-band transceiver
Objective specification
UAA3535HL
handbook, full pagewidth
TXCPO 1
VCC(TXCP) 2
TXIFA 3
IFGND1 4
TSTO 5
VCC1(IF) 6
IA 7
IB 8
QA 9
QB 10
RXON 11
TXON 12
UAA3535HL
36 IFCIA
35 IFCIB
34 IFCQA
33 IFCQB
32 VCC(RFLO)
31 RFLOIB
30 RFLOIA
29 RFLOGND
28 SYNGND
27 VCC(SYN)
26 VCC(RFCP)
25 SYNON
FCA068
Fig.2 Pin configuration.
FUNCTIONAL DESCRIPTION
RF receiver
The receiver front-end converts the aerial RF signal from
EGSM (Extended GSM; 925 to 960 MHz), DCS
(1805 to 1880 MHz) or PCS (1930 to 1990 MHz) bands
down to an IF signal of 100 kHz. The first stages are
symmetrical LNAs that are matched to 50 Ω using external
baluns. The LNAs are followed by an I/Q down-mixer.
The I/Q down-mixer consists of two mixers in parallel but
driven by quadrature out of phase LO signals.
The In-phase (I) and Quadrature- phase (Q) IF signals are
then low-pass filtered to provide protection from high
frequency offset interferers. The IF I and Q signals are
then fed into the channel filter.
Channel filter and AGC
The front-end IF I and Q outputs are first applied to an
amplifier circuit with provision for three 8 dB gain step
adjustment possibilities and then to an integrated
band-pass channel filter. The filter is a fifth-order
band-pass filter centred around 100 with 220 kHz
bandwidth. After filtering the IF I and Q signals are further
amplified with provision for eleven 4 dB gain steps and
DC offset compensation.
I/Q modulator
I and Q baseband signals are applied to the I/Q modulator
where the modulation spectrum is shifted up to the
transmit IF frequency. For low harmonic distortion, low
carrier leakage and high image rejection, the phase error
must be kept as small as possible. The IF output of the
modulator is fed to an integrated low-pass filter where
unwanted spurious signals are suppressed, prior to being
fed to the phase detector.
2000 Feb 17
5
Share Link: 