UCLAMP3306P データシートの表示（PDF） - Semtech Corporation
部品番号
コンポーネント説明
メーカー
UCLAMP3306P Datasheet PDF : 8 Pages
| |||
uClamp3306P
PROTECTION PRODUCTS
Applications Information
Device Connection Options
The μClamp3306P is designed to protect 6 signal lines
with an operating voltage of 0 to 3.3V. It will present a
high impedance to the protected line up to 3.3 volts. It
will “turn on” when the line voltage exceeds 3.5 volts.
The device is unidirectional and may be used on lines
where the signal polarity is above ground.
Pins 1, 2, 3, 4, 5, and 6 are connected to I/O signals.
The center tab is connected to system ground. All
signal lines and ground should be made with the lowest
impedance and inductance path as possible. This will
improve signal quality of the lines and keep the
clamping voltage as low as possible during a fast
transient.
EPD TVS Characteristics
These devices are constructed using Semtech’s
proprietary EPD technology. The structure of the EPD
TVS is vastly different from the traditional pn-junction
devices. At voltages below 5V, high leakage current
and junction capacitance render conventional ava-
lanche technology impractical for most applications.
However, by utilizing the EPD technology, these devices
can effectively operate at 3.3V while maintaining
excellent electrical characteristics.
The EPD TVS employs a complex nppn structure in
contrast to the pn structure normally found in tradi-
tional silicon-avalanche TVS diodes. The EPD mecha-
nism is achieved by engineering the center region of
the device such that the reverse biased junction does
not avalanche, but will “punch-through” to a conduct-
ing state. This structure results in a device with supe-
rior DC electrical parameters at low voltages while
maintaining the capability to absorb high transient
currents.
Figure 1 - Circuit Diagram
1
2
3
4
5
6
Center Tab (GND)
Figure 2 - Layout Example
Figure 3 - EPD TVS IV Characteristic Curve
IPP
ISB
IPT
VF
IR
IF
VRWM VSB VPT VC
© 2007 Semtech Corp.
5
www.semtech.com
Share Link: 