UPC4558G2-E1 データシートの表示（PDF） - NEC => Renesas Technology

部品番号

コンポーネント説明

メーカー

UPC4558G2-E1

HIGH PERFORMANCE DUAL OPERATIONAL AMPLIFIER

NEC => Renesas Technology 

µPC4558

RECOMMENDED SOLDERING CONDITIONS

The µPC4558 should be soldered and mounted under the following recommended conditions.

For soldering methods and conditions other than those recommended below, contact an NEC Electronics sales

representative.

For technical information, see the following website.

Semiconductor Device Mount Manual (http://www.necel.com/pkg/en/mount/index.html)

Type of Surface Mount Device

µPC4558G2: 8-pin plastic SOP (5.72 mm (225))

Process

Conditions

Infrared Ray Reflow

Peak temperature: 230°C or below (Package surface temperature),

Reflow time: 30 seconds or less (at 210°C or higher),

Maximum number of reflow processes: 1 time.

Vapor Phase Soldering

Peak temperature: 215°C or below (Package surface temperature),

Reflow time: 40 seconds or less (at 200°C or higher),

Maximum number of reflow processes: 1 time.

Wave Soldering

Partial Heating Method

Solder temperature: 260°C or below, Flow time: 10 seconds or less,

Maximum number of flow processes: 1 time,

Pre-heating temperature: 120°C or below (Package surface temperature).

Pin temperature: 300°C or below,

Heat time: 3 seconds or less (Per each side of the device).

Symbol

IR30-00-1

VP15-00-1

WS60-00-1

–

Caution Apply only one kind of soldering condition to a device, except for "partial heating method", or the

device will be damaged by heat stress.

Type of Through-hole Device

µPC4558C: 8-pin plastic DIP (7.62 mm (300))

Process

Conditions

Wave Soldering

(only to leads)

Solder temperature: 260°C or below,

Flow time: 10 seconds or less.

Partial Heating Method

Pin temperature: 300°C or below,

Heat time: 3 seconds or less (per each lead).

Caution For through-hole device, the wave soldering process must be applied only to leads, and make sure

that the package body does not get jet soldered.

10

Data Sheet G10518EJAV0DS

Share Link: