X24C04-2.7 データシートの表示（PDF） - Xicor -> Intersil

部品番号

コンポーネント説明

メーカー

X24C04-2.7

Serial EEPROM

Xicor -> Intersil 

X24C04

ABSOLUTE MAXIMUM RATINGS

Temperature under bias ........................–65 to +135°C

Storage temperature .............................–65 to +150°C

Voltage on any pin with

respect to VSS .................................. –1.0V to +7.0V

D.C. output current .............................................. 5 mA

Lead temperature (soldering, 10 Seconds) ........300°C

COMMENT

Stresses above those listed under “Absolute Maximum

Ratings” may cause permanent damage to the device.

This is a stress rating only; functional operation of the

device (at these or any other conditions above those

indicated in the operational sections of this specification) is

not implied. Exposure to absolute maximum rating condi-

tions for extended periods may affect device reliability.

RECOMMENDED OPERATING CONDITIONS

Temperature

Commercial

Industrial

Min.

0°C

–40°C

Max.

70°C

+85°C

Supply Voltage

X24C04-2.7

Limits

2.7V to 5.5V

D.C. OPERATING CHARACTERISTICS (Over recommended operating conditions unless otherwise specified)

Symbol

ICC1

ICC2

ISB(1)

Parameter

VCC supply current (Read)

VCC supply current (Write)

VCC standby current

ILI

ILO

VlL(2)

VIH(2)

VOL

Input leakage current

Output leakage current

Input low voltage

Input high voltage

Output low voltage

Limits

Min.

Max.

1

1.5

10

–1.0

VCC x 0.7

10

10

VCC x 0.3

VCC + 0.5

0.4

Unit

mA

µA

µA

µA

V

V

V

Test Conditions

SCL = VCC x 0.1/Vd x 0.9 Levels @

400 kHz, SDA = Open, All Other

Inputs = GND or VCC – 0.3V

SCL = SDA = VCC – 0.3V, All Other

Inputs = GND or VCC, VCC = 5.5V

VIN = GND to VCC

VOUT = GND to VCC

IOL = 3 mA, VCC ≥ 2.7V

CAPACITANCE TA = 25°C, f = 1.0MHz, VCC = 5V

Symbol

CI/O(3)

CIN(3)

Parameter

Input/output capacitance (SDA)

Input capacitance (A0, A1, A2, SCL)

Max.

8

6

Unit

pF

pF

Test Conditions

VI/O = 0V

VIN = 0V

Notes: (1) Must perform a stop command prior to measurement.

(2) VIL min. and VIH max. are for reference only and are not tested.

(3) This parameter is periodically sampled and not 100% tested.

REV 1.1.3 11/28/00

www.xicor.com

Characteristics subject to change without notice. 8 of 13

Share Link: