BA6845FS-E2 データシートの表示（PDF） - ROHM Semiconductor

部品番号

コンポーネント説明

メーカー

BA6845FS-E2

Stepping motor driver

ROHM Semiconductor 

Motor driver ICs

FApplication example

BA6845FS

FOperation notes

(1) Control logic pins

Do not apply voltage to control logic pins (pins 4, 5, 12,

and 13) when the VCC voltage is not applied to the IC. The

voltage of each pin should be less than VCC, if applied,

and should be more than the ground voltage.

(2) PCB arrangement

When changing the rotational direction of a motor, a large

current of up to a few hundred milliamperes can flow be-

tween the motor power supply (pins 11 and 14) and

MGND (pins 1 and 8). Depending on the application, this

large output current may flow back to input pins, resulting

in output oscillation or other malfunctions. Make sure that

your design does not allow a common impedance be-

tween the large current output lines and the input section.

Suppress the power supply impedance to low levels,

otherwise output oscillation may occur.

(3) Package power dissipation

The power dissipated by the IC varies widely with the

supply voltage and the output current. Give full consider-

ation to the package power dissipation rating when set-

ting the supply voltage and the output current.

(4) Ground pins

Pins 1, 3, 6, and 8 should have the lowest potential

(ground potential) in the IC.

(5) Thermal shutdown circuit

This circuit shuts down all the driver outputs when the

chip junction temperature is increased to about 175_C

(typical). The thermal shutdown circuit is deactivated

when the temperature drops to about 20_C (typical).

(6) Input pins (pins 4, 5, 12, and 13)

These pins have characteristics negatively correlated to

temperature. Give full consideration to the temperature

effect when using the IC.

739

Share Link: