TEA1716T データシートの表示（PDF） - NXP Semiconductors.

部品番号

コンポーネント説明

メーカー

TEA1716T

Resonant power supply control IC with PFC

NXP Semiconductors. 

NXP Semiconductors

UBA2071; UBA2071A

Half bridge control IC for CCFL backlighting

UBA2071

FS

GH

CFS

VDD

SH

GL

PGND

Fig 3. Basic half bridge inverter

VHV

QHS

VHB

LOAD 0.5 VHV

QLS

Cblock

014aaa100

8.1 Supply, Start-up and UnderVoltage LockOut (UVLO)

AUXILARY

SUPPLY

start

up

current

C1

UBA2071

VDD

014aaa101

Fig 4. Supply configuration (for UBA2071 only)

The UBA2071 is supplied via the VDD pin as shown in Figure 4. The supply voltage is

either made by the inverter itself, using a ∆V/∆t or is a auxiliary fixed supply voltage. A

start-up current source that can supply minimal Istartup(VDD) is needed for start-up. This can

be a resistor to the half bridge supply voltage.

The IC starts up when the voltage at the VDD pin goes over Vstartup(VDD) and shuts down

when the voltage at the VDD pin drops below Vstop(VDD) and the output GL is high1. The

hysteresis between the start and stop levels allows the IC to be supplied by the supply

buffer capacitor (C1 in Figure 4) until the auxiliary supply is settled. The auxiliary supply

must not exceed the maximum voltage allowed on the VDD pin and has to be above

Vstop(VDD).

The UBA2071A can directly be supplied by a fixed voltage source on the VDD pin. The

voltage supplied by this source has to be above the maximum value of Vstartup(VDD) but

below the maximum of VVDD. Typically it will be a 12 V ± 5 % source.

1. When both GH and GL are low, during the lamps-off period of PWM dimming (PWMD is high), the IC will shut down until the

PWMD is low and the GL is high again.

UBA2071_A_1

Product data sheet

Rev. 01 — 23 June 2008

© NXP B.V. 2008. All rights reserved.

7 of 35

Share Link: