PM6685 データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

PM6685

Dual step-down main supply controller with auxilary voltages for notebook system power

STMicroelectronics 

Pin settings

PM6685

2.2

Functions

Table 2. Pin functions

Pin Name

Description

Signal ground. Reference for internal logic circuitry. It must be connected to the

1 SGND1 signal ground plan of the power supply. The signal ground plan and the power

ground plan must be connected together in one point near the PGND pin.

2 COMP3 DC voltage error compensation pin for the 3.3V switching section.

Frequency selection pin.

3

FSEL It provides a selectable switching frequency, allowing , allowing three different

values of switching frequencies for the 5V/3.3V switching sections.

3.3V SMPS enable input.

– The 3.3V section is enabled applying a voltage greater than 2.4V to this pin.

4

EN3

– The 3.3V section is disabled applying a voltage lower than 0.8V.

When the section is disabled the High Side gate driver goes low and Low Side

gate driver goes high. If both EN3 and EN5 pins are low and SHDN pin is high

the device enters in standby mode.

Shutdown control input.

– The device switch off if the SHDN voltage is lower than 0.8V (Shutdown

mode)

5

SHDN – The device switch on if the SHDN voltage is greater than 1.7V.

The SHDN pin can be connected to the battery through a voltage divider to

program an undervoltage lockout. In shutdown mode, the gate drivers of the two

switching sections are in high impedance (high-Z).

PGOOD Power Good signal for the 3.3V linear regulator. This pin is an open drain output.

6

It is shorted to GND if LDO3_SEL pin is at its low level or if the output voltage

LDO3 on LDO3 pin is lower than 2.6V.

7

LDO3 3.3V Linear regulator output. LDO3 can provide 100mA peak current.

8

OUT3

Output voltage sense for the 3.3V switching section.This pin must be directly

connected to the output voltage of the switching section.

9

BOOT3

Bootstrap capacitor connection for the switching 3.3V section. It supplies the

high-side gate driver.

10 HGATE3 High-side gate driver output for the 3.3V section.

11

PHASE3

Switch node connection and return path for the high side driver for the 3.3V

section.

Current sense input for the 3.3V section. This pin must be connected through a

12 CSENSE3 resistor to the drain of the synchronous rectifier (RDSON sensing) to set the

current limit threshold.

13 LGATE3 Low-side gate driver output for the 3.3V section.

14

PGND

Power ground. This pin must be connected to the power ground plan of the

power supply.

15 LGATE5 Low-side gate driver output for the 5V section.

16

SGND2

Signal ground for analog circuitry. It must be connected to the signal ground

plan of the power supply.

6/52

Share Link: