SRV05-4(2004) データシートの表示（PDF） - Semtech Corporation

部品番号

コンポーネント説明

メーカー

SRV05-4
(Rev.:2004)

RailClamp® Low Capacitance TVS Diode Array

Semtech Corporation 

SRV05-4

PROTECTION PRODUCTS

DVI Protection

10/100 ETHERNET PROTECTION

The small geometry of a typical digital-visual interface

(DVI) graphic chip will make it more susceptible to

electrostatic discharges (ESD) and cable discharge

events (CDE). Transient protection of a DVI port can

be challenging. Digital-visual interfaces can often

transmit and receive at a rate equal to or above

1Gbps. The high-speed data transmission requires the

protection device to have low capacitance to maintain

signal integrity and low clamping voltage to reduce

stress on the protected IC. The SRV05-4 has a low

typical insertion loss of <0.4dB at 1GHz (I/O to ground)

to ensure signal integrity and can protect the DVI

interface to the 8kV contact and 15kV air ESD per IEC

61000-4-2 and CDE.

Figure 7 shows how to design the SRV05-4 into the

DVI circuit on a flat panel display and a PC graphic

card. The SRV05-4 is configured to provide common

mode and differential mode protection. The internal

TVS of the SRV05-4 acts as a 5 volt reference. The

power pin of the DVI circuit does not come out through

the connector and is not subjected to external ESD

pulse; therefore, pin 5 should be left unconnected.

Connecting pin 5 to Vcc of the DVI circuit may result in

damage to the chip from ESD current.

Ethernet ICs are vulnerable to damage from electro-

static discharge (ESD). The internal protection in the

PHY chip, if any, often is not enough due to the high

energy of the discharges specified by IEC 61000-4-2.

If the discharge is catastrophic, it will destroy the

protected IC. If it is less severe, it will cause latent

failures that are very difficult to find.

10/100 Ethernet operates at 125MHz clock over a

twisted pair interface. In a typical system, the twisted-

pair interface for each port consists of two differential

signal pairs: one for the transmitter and one for the

receiver, with the transmitter input being the most

sensitive to damage. The fatal discharge occurs

differentially across the transmit or receive line pair

and is capacitively coupled through the transformer to

the Ethernet chip. Figure 8 shows how to design the

SRV05-4 on the line side of a 10/100 ethernet port to

provide differential mode protection. The common

mode isolation of the transformer will provide common

mode protection to the rating of the transformer

isolation which is usually >1.5kV. If more common

mode protection is needed, figure 9 shows how to

design the SRV05-4 on the IC side of the 10/100

 2004 Semtech Corp.

Figure 7 - Digital Video Interface (DVI) Protection

8

www.semtech.com

Share Link: