TSH95 データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

TSH95

High-speed low-power quad operational amplifier with dual standby position

STMicroelectronics 

Electrical characteristics

Figure 2. Standby position

VCC+

Standby

TSH95

VCC-

To put the device in standby, a logic level must be applied on the standby MOS input. Since

ground is a virtual level for the device, the threshold voltage has been referred to VCC+ at

VCC+ -1.6 V typical.

In standby mode, the output goes into high impedance in 200 ns. Note that all maximum

ratings must still be followed in this mode. This mode leads to a swing limitation while using

the device in a signal multiplexing configuration with followers; the differential input voltage

must not exceed ±5 V, limiting the input swing to 2.5 Vpp.

6/18

Doc ID 5243 Rev 3

Share Link: