BM29F400B-12TC データシートの表示（PDF） - Unspecified
部品番号
コンポーネント説明
メーカー
BM29F400B-12TC Datasheet PDF : 38 Pages
| |||
BRIGHT
Microelectronics
Inc.
Preliminary BM29F400T/BM29F400B
command must be less than 80 mS to guarantee acceptance of the command by the internal state
machine. The time-out window can be monitored via the write operation status pin DQ3 (refer to the
Write Operation Status section for Sector Erase Timer operation). It is recommended that CPU
interrupts be disabled during this time to ensure that the subsequent Sector Erase commands can be
initiated within the 100 uS window. The interrupts can be re-enabled after the last Sector Erase
command is written. As mentioned above, an internal device timer will initiate the Sector Erase
operation 100 uS ±20% (80 uS to 120 uS) from the rising edge of the last WE pulse. Sector Erase
Timer Write Operation Status pin (DQ3) can be used to monitor time out window. If another falling
edge of the WE occurs within the 100 mS time-out window, the internal device timer is reset.
Loading the sector erase buffer may be done in any sequence and with any number of sectors.
Any command other than Sector Erase or Erase Suspend during this period and afterwards will
RESET the device to read mode, ignoring the previous command string. Resetting the device with a
hardware RESET after it has begun execution of a Sector Erase operation will result in the data in
the operated sectors being undefined and may be unrecoverable. In this case, restart the Sector
Erase operation on those sectors and attempt to allow them to complete the Erase operation.
Command Definitions
Device operations are selected by writing specific address and data sequences in to the Command
register. Writing incorrect addresses and data values or writing them in the improper sequence will
RESET the device to Read mode. Table 5 defines the valid register command sequences. Either of
the two Read/Reset commands will RESET the device (when applicable).
During Sector Erase operation, data bit DQ7 shows a logical "0". This operation is known as Data
Polling. Sector Erase operation is complete when data on DQ7 is a logical "1" (see Write Operation
Status section) at which time the device returns to read mode. At this time, the address pins are no
longer latched. Note that Data Polling must be performed at a sector address within any of the
sectors being erased and not a protected sector to ensure that DQ7 returns a logical "1" upon
completion of the Sector Erase operation.
Figure 2 illustrates the Sector Erase Algorithm using typical command strings and bus operations.
During execution of the Sector Erase command, only the Erase Suspend and Erase Resume
commands are allowed. All other commands will RESET the device to read mode.
Note: Do not attempt to write an invalid command sequence during the sector erase operation. Doing so will terminate the sector
erase operation and the device will /RESET to the read mode.
A Winbond Company
- 11 -
Publication Release Date: May 1999
Revision A1
Share Link: 