ARM-JTAG-SWD データシートの表示（PDF） - Unspecified

部品番号

コンポーネント説明

メーカー

ARM-JTAG-SWD

STM32-P407 development board USER’S MANUAL

Unspecified 

OLIMEX© 2014

STM32-P407 user's manual

Workbench, Rowley CrossWorks, etc.

Olimex distributes a free IDE that works with our OpenOCD programmers:

https://www.olimex.com/Products/ARM/JTAG/_resources/OpenOCD/.

At the moment of writing this guide our ARM programmers/debuggers equipped with an ARM-

JTAG-SWD work fine (out-of-the-box) with Rowley CrossWorks.

2.3 Powering the board

Provide +5 V DC to the board's power jack, OR +5 V via the JTAG or TRACE connector (before

providing the power set the PWR_SEL jumper in the correct position)

Additionally the board can be powered using the PROTO AREA pads. Provide 5V to the respective

pad with the same label. Ground pad is named AGND.

On powering the board the PWR LED, the SATA4 LED and the display should turn on. The

SATA1, SATA2 and SATA3 LEDs must start blinking consecutively.

If measuring the current consumption it should be around 30 mA.

2.4 Prebuilt software

On arrival the board has a basic demo installed which features test of the LEDs, the LCD, the

joystick, the camera.

Note that the demo provided by Olimex LTD is the same as the demo provided for STM32-P207

though not optimized for the F407 processor.

IMPORTANT: If you have only a programmer with JTAG interface and you need to turn off the

peripherals using the JTAG signals press WKUP button (if there is a reset after programming you

might need to keep it pressed)! Pressing WKUP button will turn off those modules and will allow

JTAG reprogramming. T

Page 8 of 32

Share Link: