NRF8001-R2Q32-T データシートの表示（PDF） - Unspecified

部品番号

コンポーネント説明

メーカー

NRF8001-R2Q32-T

Single-chip Bluetooth® low energy solution

Unspecified 

nRF8001 Product Specification

1

Introduction

nRF8001 is a Bluetooth® low energy solution designed for operation in the peripheral role. By integrating a

Bluetooth low energy compliant radio (PHY), slave mode link controller, and host, nRF8001 offers you an

easy way to add Bluetooth low energy connectivity to your application.

nRF8001 offers a serial interface (ACI) for configuration and control from your microcontroller. This

microcontroller will in the remainder of this document be referred to as the application controller.

This document is divided into two parts:

• Part A defines the nRF8001 hardware and electrical specifications as well as operating procedures.

• Part B describes the Application Controller Interface (ACI); the logical interface between the

nRF8001 and your application

1.1

Prerequisites

To fully understand this document, knowledge of electronic and software engineering is required.

Knowledge of Bluetooth Core specification v4.0, Volumes 1, 3, 4, and 6 is required to operate nRF8001

correctly and to understand the terminology used within this document.

1.2

Writing conventions

This product specification follows a set of typographic rules to ensure that the document is consistent and

easy to read. The following writing conventions are used:

• Command and event names, bit state conditions, and register names are written in Courier.

• Pin names and pin signal conditions are written in Courier New bold.

• Placeholders for parameters are written in italic regular text font. For example, a syntax description

of Connect will be written as: Connect(TimeOut, AdvInterval).

• Fixed parameters are written in regular text font. For example, a syntax description of Connect will

be written as: Connect(0x00F0, Interval).

• Cross references are underlined and highlighted in blue.

1.3

Bluetooth specification releases

This document is valid based on Bluetooth Core specification v4.0 for a low energy device operating in the

peripheral role.

Revision 1.2

Page 8 of 161

Share Link: