AT88SA10HS-TSU-T データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

AT88SA10HS-TSU-T

Atmel CryptoAuthentication Host Security Chip

Atmel Corporation 

5.1.2

Transmit Flag

The Transmit flag is used to turn around the signal so that the AT88SA10HS can send data back to the system, depending on

its current state. The bytes that the AT88SA10HS returns to the system depend on its current state as follows:

Table 5-3. Return Codes

State Description

After Wake, but prior to

first command

After successful command

execution

Execution error

After CRC or other

communications error

Error/Status Description

0x11

Indication that a proper Wake token has been received by AT88SA10HS

–

0x0F

0xFF

Return bytes per “Output Parameters” in Command section of this document.

In some cases this is a single byte with a value of 0x00 indicating success.

The Transmit flag can be re-sent to AT88SA10HS repeatedly if a re-read of

the output is necessary

Command was properly received but could not be executed by

AT88SA10HS. Changes in the AT88SA10HS state or the value of the

command bits must happen before it is re-attempted

Command was not properly received by AT88SA10HS and should be re-

issued by the system. No attempt was made to execute the command

The AT88SA10HS always transmits complete blocks to the system, so in the above table, the status/error bytes result in four

bytes going to the system – count, error, CRC x 2.

After receipt of a command block, the AT88SA10HS will parse the command for errors, a process which takes tPARSE (See

Section 5.1.1). After this interval the system can send a transmit token to the AT88SA10HS – if there was an error, the

AT88SA10HS will respond with an error code. If there is no error, the AT88SA10HS internally transitions automatically from

tPARSE to tEXEC and will not respond to any transmit tokens until both delays are complete.

5.1.3

Sleep Flag

The sleep flag is used to transition the AT88SA10HS to the low power state, which causes a complete reset of the internal

command engine of the AT88SA10HS and input/output buffer. It can be sent to AT88SA10HS at any time when AT88SA10HS

will accept a flag.

To achieve the specified I SLEEP, Atmel recommends that the input signal be brought below VIL when the chip is asleep. To

achieve ISLEEP if the sleep state of the input pin is high, the voltage on the input signal should be within 0.3V of VCC to avoid

additional leakage on the input circuit of the chip.

The system must calculate the total time required for all commands to be sent to the AT88SA10HS during a single session,

including any inter-bit/byte delays. If this total time exceeds tWATCHDOG then the system must issue a partial set of commands,

then a Sleep flag, then a Wake token, and finally after the Wake delay, issue the remaining commands.

Atmel AT88SA10HS [DATASHEET]

9

8595G−CRYPTO−9/11

Share Link: