MX25L6406EMI-12G データシートの表示（PDF） - Macronix International

部品番号

コンポーネント説明

メーカー

MX25L6406EMI-12G

64M-BIT [x 1 / x 2] CMOS SERIAL FLASH

Macronix International 

MX25L6406E

7. DEVICE OPERATION

1. Before a command is issued, status register should be checked to ensure device is ready for the intended op-

eration.

2. When incorrect command is inputted to this LSI, this LSI becomes standby mode and keeps the standby mode

until next CS# falling edge. In standby mode, SO pin of this LSI should be High-Z. The CS# falling time needs to

follow tCHCL spec.

3. When correct command is inputted to this LSI, this LSI becomes active mode and keeps the active mode until

next CS# rising edge. The CS# rising time needs to follow tCLCH spec.

4. Input data is latched on the rising edge of Serial Clock(SCLK) and data shifts out on the falling edge of SCLK.

The difference of Serial mode 0 and mode 3 is shown in "Figure 1. Serial Modes Supported".

5. For the following instructions:RDID, RDSR, RDSCUR, READ, FAST_READ, RDSFDP, DREAD, RES, and

REMS the shifted-in instruction sequence is followed by a data-out sequence. After any bit of data being shifted

out, the CS# can be high. For the following instructions: WREN, WRDI, WRSR, SE, BE, CE, PP, RDP, DP,

ENSO, EXSO,and WRSCUR, the CS# must go high exactly at the byte boundary; otherwise, the instruction will

be rejected and not executed.

6. During the progress of Write Status Register, Program, Erase operation, to access the memory array is neglect-

ed and not affect the current operation of Write Status Register, Program, Erase.

Figure 1. Serial Modes Supported

CPOL CPHA

(Serial mode 0) 0

0

SCLK

(Serial mode 3) 1

1

SCLK

SI

SO

shift in

MSB

shift out

MSB

Note:

CPOL indicates clock polarity of Serial master, CPOL=1 for SCLK high while idle, CPOL=0 for SCLK low while not

transmitting. CPHA indicates clock phase. The combination of CPOL bit and CPHA bit decides which Serial mode is

supported.

P/N: PM1577

REV. 1.8, NOV. 12, 2013

10

Share Link: