ADM705(2000) データシートの表示（PDF） - Analog Devices
部品番号
コンポーネント説明
メーカー
| ADM705 Datasheet PDF : 0 Pages | |||
ADM705–ADM708
Power-Fail Comparator
The power-fail comparator is an independent comparator that
may be used to monitor the input power supply. The comparator’s
inverting input is internally connected to a 1.25 V reference
voltage. The noninverting input is available at the PFI input.
This input may be used to monitor the input power supply via
a resistive divider network. When the voltage on the PFI input
drops below 1.25 V, the comparator output (PFO) goes low,
indicating a power failure. For early warning of power failure,
the comparator may be used to monitor the preregulator input
simply by choosing an appropriate resistive divider network.
The PFO output can be used to interrupt the processor so that
a shutdown procedure is implemented before the power is lost.
INPUT
POWER
R1
1.25V
PFO
POWER-FAIL PFI
R2
INPUT
ADM70x
POWER-FAIL
OUTPUT
Figure 5. Power-Fail Comparator
Adding Hysteresis to the Power-Fail Comparator
For increased noise immunity, hysteresis may be added to the
power-fail comparator. Since the comparator circuit is non-
inverting, hysteresis can be added simply by connecting a
resistor between the PFO output and the PFI input as shown in
Figure 6. When PFO is low, resistor R3 sinks current from the
summing junction at the PFI pin. When PFO is high, resistor
R3 sources current into the PFI summing junction. This results
in differing trip levels for the comparator. Further noise immu-
nity may be achieved by connecting a capacitor between PFI
and GND.
7V TO 15V
INPUT POWER
R1
R2
5V
ADM663
VCC
1.25V
PFO
PFI
ADM70x
R3
TO P NMI
[ VH
= 1.25
1
+
R2
R2
+
×
R3
R3
R1]
VL
=
1.25
+
R1
1.25
R2
–
VCC
– 1.25
RE
VMID
=
1.25
R1 + R2
R2
Valid RESET Below 1 V VCC
The ADM70x family of products is guaranteed to provide a
valid reset level with VCC as low as 1 V; please refer to the Typi-
cal Performance Characteristics. As VCC drops below 1 V, the
internal transistor will not have sufficient drive to hold it ON so
the voltage on RESET will no longer be held at 0 V. A pull-down
resistor as shown in Figure 7 may be connected externally to
hold the line low if it is required.
ADM70x
RESET
GND
R1
Figure 7. RESET Valid Below 1 V
5V
PFO
0V
0V
VL
VH
VIN
Figure 6. Adding Hysteresis to the Power-Fail Comparator
REV. B
–5–
Share Link: 