DS2430AP データシートの表示（PDF） - Maxim Integrated
部品番号
コンポーネント説明
メーカー
DS2430AP Datasheet PDF : 19 Pages
| |||
DS2430A
1-WIRE BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances, the
DS2430A is a slave device. The bus master is typically a microcontroller. The discussion of this bus
system is broken down into three topics: hardware configuration, transaction sequence, and 1-Wire
signaling (signal type and timing). The 1-Wire protocol defines bus transactions in terms of the bus state
during specified time slots that are initiated on the falling edge of sync pulses from the bus master.
NS Hardware Configuration
G The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
I drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain connection or three-state outputs. The 1-Wire port of the DS2430A is open drain with an internal
S circuit equivalent to that shown in Figure 7. A multidrop bus consists of a 1-Wire bus with multiple
E slaves attached. The DS2430A communicates at regular 1-Wire speed, 15.3kbits per second, and requires
D a pullup resistor as shown in Figure 7. The idle state for the 1-Wire bus is high. If for any reason a
transaction needs to be suspended, the bus MUST be left in the idle state if the transaction is to resume. If
this does not occur and the bus is left low for more than 120µs, one or more of the devices on the bus may
W be reset.
NE HARDWARE CONFIGURATION Figure 7
RPU
FOR
RECOMMENDERPUD
IL
T Note: Depending on the 1-Wire communication speed and the bus characteristics, the optimal pullup
Oresistor value will be in the 0.3k to 2.2k range. To write to a single device, a RPUPmax resistor and
VPUP of at least 4.0V is sufficient. For writing multiple DS2430As simultaneously or operation at low
NVPUP, the resistor should be bypassed by a low-impedance pullup to VPUP while the device copies the
scratchpad to EEPROM.
9 of 19
Share Link: 