RT7237 データシートの表示（PDF） - Richtek Technology
部品番号
コンポーネント説明
メーカー
RT7237 Datasheet PDF : 15 Pages
| |||
RT7237C
Application Information
Output Voltage Setting
The resistive divider allows the FB pin to sense the output
voltage as shown in Figure 1.
VOUT
R1
FB
RT7237C
R2
GND
Figure 1. Output Voltage Setting
The output voltage is set by an external resistive voltage
divider according to the following equation :
VOUT
=
VREF
1
R1
R2
Where VREF is the reference voltage (0.8V typ.).
External Bootstrap Diode
Connect a 0.1μF low ESR ceramic capacitor between the
BOOT pin and SW pin. This capacitor provides the gate
driver voltage for the high side MOSFET.
It is recommended to add an external bootstrap diode
between an external 5V and BOOT pin for efficiency
improvement when input voltage is lower than 5.5V or duty
ratio is higher than 65% .The bootstrap diode can be a
low cost one such as IN4148 or BAT54. The external 5V
can be a 5V fixed input from system or a 5V output of the
RT7237C. Note that the external boot voltage must be
lower than 5.5V
5V
BOOT
RT7237C
SW
0.1µF
Figure 2. External Bootstrap Diode
Soft-Start
The RT7237C provides soft-start function. The soft-start
function is used to prevent large inrush current while
converter is being powered-up. The soft-start timing can
be programmed by the external capacitor between SS and
GND. An internal current source ISS (6μA) charges an
external capacitor to build a soft-start ramp voltage. The
VFB voltage will track the internal ramp voltage during soft-
start interval. The typical soft-start time is calculated as
follows :
Soft-Start time tSS
=
0.8 CSS
ISS
,
if
CSS
capacitor
is 0.1F, then soft-start time = 0.8 0.1 ≒ 13.5ms
6
Chip Enable Operation
The EN pin is the chip enable input. Pulling the EN pin
low (<0.4V) will shut down the device. During shutdown
mode, the RT7237C quiescent current drops to lower than
3μA. Driving the EN pin high (>2V, <18V) will turn on the
device again. For external timing control, the EN pin can
also be externally pulled high by adding a REN resistor
and CEN capacitor from the VIN pin (see Figure 3).
EN
REN
VIN
CEN
EN
RT7237C
GND
Figure 3. Enable Timing Control
An external MOSFET can be added to implement digital
control on the EN pin when no system voltage above 2V
is available, as shown in Figure 4. In this case, a 100kΩ
pull-up resistor, REN, is connected between VIN and the
EN pin. MOSFET Q1 will be under logic control to pull
down the EN pin.
REN
100k
VIN
EN
EN
Q1 RT7237C
GND
Figure 4. Digital Enable Control Circuit
Copyright ©2015 Richtek Technology Corporation. All rights reserved.
www.richtek.com
10
is a registered trademark of Richtek Technology Corporation.
DS7237C-05 February 2015
Share Link: 