EL2030 データシートの表示（PDF） - Intersil
部品番号
コンポーネント説明
メーカー
EL2030 Datasheet PDF : 12 Pages
| |||
EL2030
Video signals are 1V peak-peak in amplitude, from sync tip
to peak white. There are 100 IRE (0.714V) of picture (from
black to peak white of the transmitted signal) and 40 IRE
(0.286V) of sync in a composite video signal (140 IRE = 1V).
For video applications where a gain of two is used (double
termination), the output of the video amplifier will be a
maximum of 2V peak-peak. With ±5V power supply, the
EL2030 output swing of 3.5V is sufficient to satisfy the video
output swing requirements. The EL2030 can drive two
double terminated coax cables under these conditions. With
±15V supplies, driving four double terminated cables is
feasible.
Although the EL2030's video characteristics (differential gain
and phase) are impressive with ±5V supplies at NTSC and
PAL frequencies, it can be optimized when the supplies are
increased to ±15V, especially at 30MHz HDTV applications.
This is primarily due to a reduction in internal parasitic
junction capacitance with increased power supply voltage.
Equivalent Circuit
The following table summarizes the behavior of the EL2030
at ±5V and ±15V for NTSC. In addition, 30MHz HDTV data is
included. Refer to the differential gain and phase typical
performance curves for more data.
±VS RLOAD AV GAIN PHASE
COMMENTS
15V 75Ω
1 0.02% 0.03° Single terminated
15V 150Ω 1 0.02% 0.02° Double terminated
5V 150Ω 1 0.05% 0.02° Double terminated
15V 75Ω
2 0.02% 0.08° Single terminated
15V 150Ω 2 0.01% 0.02° Double terminated
5V 150Ω 2 0.03% 0.09° Double terminated
15V 150Ω
2 0.05% 0.02° HDTV, Double
terminated
10
Share Link: 