AS339AMTR-E1 データシートの表示（PDF） - BCD Semiconductor
部品番号
コンポーネント説明
メーカー
AS339AMTR-E1 Datasheet PDF : 11 Pages
| |||
LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS
Ordering Information (Continued)
Data Sheet
AS339/339A
Package
SOIC-14
DIP-14
TSSOP-14
Temperature
Range
-40 to 85oC
Part Number
Lead Free
Green
AS339M-E1
AS339M-G1
AS339MTR-E1 AS339MTR-G1
AS339AM-E1
AS339AM-G1
AS339AMTR-E1 AS339AMTR-G1
AS339P-E1
AS339P-G1
AS339GTR-E1 AS339GTR-G1
Marking ID
Lead Free
Green
AS339M-E1
AS339M-G1
AS339M-E1
AS339M-G1
AS339AM-E1 AS339AM-G1
AS339AM-E1 AS339AM-G1
AS339P-E1
AS339P-G1
EGS339
GGS339
Packing Type
Tube
Tape & Reel
Tube
Tape & Reel
Tube
Tape & Reel
BCD Semiconductor's Pb-free products, as designated with "E1" suffix in the part number, are RoHS compliant. Products with
"G1" suffix are available in green packages.
Absolute Maximum Ratings (Note 1)
Parameter
Symbol
Value
Unit
Supply Voltage
VCC
40
V
Differential Input Voltage
VID
40
V
Input Voltage
VIN
-0.3 to 40
V
Input Current (VIN<-0.3V) (Note 2)
IIN
50
mA
Output Short-Circuit to Ground
Continuous
DIP-14
1050
Power Dissipation (TA=25oC)
PD
SOIC-14
890
mW
TSSOP-14
790
Operating Junction Temperature
TJ
150
oC
Storage Temperature Range
TSTG
-65 to 150
oC
Lead Temperature (Soldering, 10 Seconds)
TLEAD
260
oC
Note 1: Stresses greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the
device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those indicated under "Recommended Operating Conditions" is not implied. Exposure to "Absolute Maximum
Ratings" for extended periods may affect device reliability.
Note 2: This input current will only exist when the voltage at any of the input leads is driven negative. It is due to
the collector-base junction of the input PNP transistors becoming forward biased and thereby acting as input diode
clamps. In addition to this diode action, there is also lateral NPN parasitic transistor action on the IC chip. This
transistor action can cause the output voltages of the comparators to go to the V+ voltage level (or to ground for a
large overdrive) for the time duration that an input is driven negative. This is not destructive and normal output
states will re-establish when the input voltage, which was negative, again returns to a value greater than -0.3 VDC
(at 25oC).
Jan. 2013 Rev. 2. 1
BCD Semiconductor Manufacturing Limited
3
Share Link: 