STR450 データシートの表示（PDF） - Unspecified
部品番号
コンポーネント説明
メーカー
STR450 Datasheet PDF : 7 Pages
| |||
RUNNING THE SOFTWARE
1.
Connect STR450 to a suitable supply and to the PC using the programming
lead.
2.
Insert the STRPRG disk into drive A and type:
A:STRPRG <return> then type:
3.
The user is then prompted to enter the serial port number of his PC which is
used to communicate with the STR450 receiver. Enter 1 or 2.
After the software has successfully loaded the main menu screen is displayed as shown
in Figure 6. The screen shows the default settings which are entered at factory set-up.
These default settings will be displayed whenever the STRPRG software is run.
Please note that mouse operation is not supported with this program.
STR450 Programmer
Chan 0 458.5
Chan 1 458.5125
Chan 2 458.525
Chan 3 458.5375
Chan 4 458.55
Chan 5 458.5625
Chan 6 458.575
Chan 7 458.5875
Chan 8 458.6
Chan 9 458.6125
Chan 10 458.625
Chan 11 458.6375
Chan 12 458.65
Chan 13 458.6625
Chan 14 458.675
Chan 15 458.6875
Start table 458.7
Max. Freq. 458.95
Table step 1 x 12.5
Synth. step freq. 12.5 KHz
MHZ <<
Mhz
Ref. (TCXO) freq. 8 MHz
Mhz
Intermediate freq. 21.4 MHz
Mhz
Mhz
Serial channel selected: 0
Mhz
Mhz
COMMANDS:
Mhz
Mhz
F2 : copy Ch 16-31 to Ch 0-15
Mhz
F5 : read from unit
Mhz
F6 : program unit
Mhz
F8 : Select channel
Mhz
Mhz
F9 : set synth. step freq.
Mhz
F10 : set TCXO freq.
Mhz
F11 : set Intermediate freq.
F12 : QUIT
MHZ
Mhz
Sequential frequencies, Chan. 16 to 127
Khz
Figure 5 Screen Display
Share Link: 