IR5001S データシートの表示（PDF） - International Rectifier

部品番号

コンポーネント説明

メーカー

IR5001S

UNIVERSAL ACTIVE ORING CONTROLLER

International Rectifier 

IR5001S & (PbF)

PARAMETERS

Output Section

High Level Output Voltage

Low Level Output Voltage

Turn-On DelayTime

Rise Time

Turn-Off Delay Time

Fall Time

FETch and FETst

FETch Sink Current

FETch Output Delay Time

FETch Threshold

FETst Threshold Voltage

FETst Low Level Output

Voltage

SYMBOL

Vout HI

Vout LO

td(on)

tr

td(off)

tf

TEST CONDITION

Vline=25V, IOH=50uA,

V(INN)=-0.3V

IOL=100mA, V(INN)=+0.3V

Vout switching from LO to HI, Fig.5

Vout switching from HI to LO, Fig.5

MIN TYP MAX UNITS

10.2 11.5 14.1 V

0.1 V

5 27 45 us

0.09 0.7 1 ms

110 130 170

ns

10 26 39

I(FETch)

FETch=5V

-0.5 -1.1 -2 uA

FETch_pd

Vth(FETch)

Note 1

0.8 1.8 us

0.9 1.2 1.5 V

5k resistor from FETst to 5V logic bias.

Vth(FETst) V(INP) = Gnd, V(INN) ramping down -525 -300 -200 mV

from 0 until FETst switches to Low.

VOL

Isink=1mA, V(INN)=-0.5V

0 50 100 mV

Note 1: Guaranteed by design but not tested in production.

Note 2: Low Vcc output voltage corresponds to low UVLO voltage

PIN DESCRIPTIONS

PIN#

1

PIN SYMBOL

PIN DESCRIPTION

Vline

IC power supply pin for 36V to 75V input communications systems.

Minimum 25V has to be applied at this pin to bias the IC.

Output pin of the internal shunt regulator, or input pin for biasing the IC via

2

Vcc

external resistor. This pin is internally regulated at 12.5V typical. A

minimum 0.1uF capacitor must be connected from this pin to Gnd of IR5001.

FET check input pin. Together with FET status output pin, the FETch pin

3

F E Tc h

can be used to determine the state of the Active ORing circuit and power

system redundancy.

FET status output pin. Together with FETch input pin, the FETst pin can be

4

F E Ts t

used to determine the state of the Active ORing circuit and power system

redundanc y .

5

INP

Positive input of internal comparator. This pin should connect to the source

of N-channel Active ORing MOSFET.

6

INN

Negative input pin of internal comparator. This pin should connect to the

drain of N-channel Active ORing MOSFET.

7

Gnd

Ground pin of the IR5001.

8

Vout

Output pin for the IR5001. This pin is used to directly drive the gate of the

Active Oring N-Channel MOSFET.

www.irf.com

3

Share Link: