AS1362 データシートの表示（PDF） - austriamicrosystems AG

部品番号

コンポーネント説明

メーカー

AS1362

150mA/300mA, Ultra-Low-Noise, High-PSRR Low Dropout Regulators, with POK

austriamicrosystems AG 

AS1361/AS1362

Datasheet - Detailed Description

8 Detailed Description

The AS1361/AS1362 are ultra-low-noise, low-dropout, low-quiescent current linear-regulators specifically designed for

space-limited applications. The devices are available with preset output voltages from 1.5 to 4.5V in 50mV increments.

These devices can supply loads up to 150/300mA. As shown in Figure 18, the AS1361/AS1362 consist of an inte-

grated bandgap core and noise bypass circuitry, error amplifier, P-channel MOSFET pass transistor, and internal feed-

back voltage-divider.

The output voltage is fed back through an internal resistor voltage-divider connected to pin OUT. An external bypass

capacitor connected to pin BYPASS reduces noise at the output. Additional blocks include a current limiter, thermal

sensor, and shutdown logic.

Internal Voltage Reference

The 1.25V bandgap reference is connected to the error amplifier’s inverting input. The error amplifier compares this

reference with the feedback voltage and amplifies the difference. If the feedback voltage is lower than the reference

voltage, the pass-transistor gate is pulled low. This allows more current to pass to the output and increases the output

voltage. If the feedback voltage is too high, the pass transistor gate is pulled high, allowing less current to pass to the

output.

Internal P-Channel Pass Transistor

The AS1361/AS1362 feature a 0.5Ω (typ) P-channel MOSFET pass transistor, which provides several advantages

over similar designs using a PNP pass transistor, including prolonged battery life. The P-channel MOSFET does not

require a base driver, thus quiescent current is dramatically reduced. The AS1361/AS1362 LDOs do not exhibit prob-

lems associated with typical PNP-based LDOs, and consume only 40µA of quiescent current in light load and 220µA in

dropout (see Typical Operating Characteristics on page 6).

Output Voltage

The AS1361/AS1362 deliver preset output voltages from 1.5 to 4.5V, in 50mV increments (see Ordering Information on

page 14).

Shutdown

The AS1361/AS1362 feature a low-power shutdown mode that reduces quiescent current to <200nA. Driving SHDNN

low disables the internal voltage reference, error amplifier, gate-drive circuitry, and P-channel MOSFET pass transistor

(see Figure 18), and the device output enters a high-impedance state.

Note: For normal operation connect pin SHDNN to pin IN.

www.austriamicrosystems.com

Revision 1.03

9 - 15

Share Link: