MAX4609CSE データシートの表示（PDF） - Maxim Integrated
部品番号
コンポーネント説明
メーカー
MAX4609CSE Datasheet PDF : 12 Pages
| |||
2.5Ω, Dual, SPST,
CMOS Analog Switches
ELECTRICAL CHARACTERISTICS—Single Supply (continued)
(V+ = +12V, V- = 0, VL = +5V, VIN_H = +2.4V, VIN_L = +0.8V, TA = TMIN to TMAX, unless otherwise noted. Typical values are at
TA = +25°C.) (Note 2)
PARAMETER
POWER SUPPLY
Power-Supply Range
Positive Supply Current
SYMBOL
I+
Logic Supply Current
IL
Ground Current
IGND
SWITCH DYNAMIC CHARACTERISTICS
Turn-On Time
tON
Turn-Off Time
tOFF
Charge Injection
Q
CONDITIONS
MIN
VIN = 0 or 5V
VIN = 0 or 5V
VIN = 0 or 5V
TA = +25°C
TA = TMIN to TMAX
TA = +25°C
TA = TMIN to TMAX
TA = +25°C
TA = TMIN to TMAX
+4.5
-0.5
5
-0.5
5
-0.5
5
VCOM_ = 10V, Figure 2, TA = +25°C
VCOM_ = 10V, Figure 2, TA = +25°C
CL = 1.0nF, VGEN = 0, RGEN = 0, Figure 3,
TA = +25°C
TYP MAX UNITS
+36.0
V
0.001 0.5
µA
5
0.001 0.5
µA
5
0.001 0.5
µA
5
110
ns
130
ns
50
pC
Crosstalk (Note 8)
VCT
RL = 50Ω, CL = 5pF, f = 1MHz, Figure 5,
TA = +25°C
66
dB
NC or NO Capacitance
COM Off-Capacitance
On-Capacitance
C(OFF)
C(COM)
C(COM)
f = 1MHz, Figure 6, TA = +25°C
f = 1MHz, Figure 6, TA = +25°C
f = 1MHz, Figure 7, TA = +25°C
105
pF
105
pF
185
pF
Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3: Guaranteed by design.
Note 4: ∆RON = RON(MAX) - RON(MIN)
Note 5: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal range.
Note 6: Leakage parameters are 100% tested at maximum-rated hot temperature and guaranteed by correlation at +25°C.
Note 7: Off-isolation = 20log10 [VCOM / (VNC or VNO)], VCOM = output, VNC or VNO = input to off switch.
Note 8: Between any two switches.
Note 9: Leakage testing at single supply is guaranteed by testing with dual supplies.
_______________________________________________________________________________________ 5
Share Link: 