DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

ADM2582EBRWZ1(2009) データシートの表示(PDF) - Analog Devices

部品番号
コンポーネント説明
メーカー
ADM2582EBRWZ1 Datasheet PDF : 20 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
GND1 1
VCC 2
GND1 3
RxD 4
RE 5
DE 6
TxD 7
VCC 8
GND1 9
GND1 10
20 GND2
19 VISOIN
18 A
ADM2582E 17 B
ADM2587E
TOP VIEW 16 GND2
(Not to Scale) 15 Z
14 GND2
13 Y
12 VISOOUT
11 GND2
NOTES
1. PIN 12 AND PIN 19 MUST BE
CONNECTED EXTERNALLY.
Figure 2. Pin Configuration
ADM2582E/ADM2587E
Table 10. Pin Function Description
Pin No. Mnemonic Description
1
GND1
Ground, Logic Side.
2
VCC
Logic Side Power Supply. It is recommended that a 0.1 μF and a 10 μF decoupling capacitor be fitted between
Pin 2 and Pin 1.
3
GND1
Ground, Logic Side.
4
RxD
Receiver Output Data. This output is high when (A − B) > 200 mV and low when (A − B) < –200 mV.
The output is tristated when the receiver is disabled, that is, when RE is driven high.
5
RE
Receiver Enable Input. This is an active-low input. Driving this input low enables the receiver; driving it
high disables the receiver.
6
DE
Driver Enable Input. Driving this input high enables the driver; driving it low disables the driver.
7
TxD
Driver Input. Data to be transmitted by the driver is applied to this input.
8
VCC
Logic Side Power Supply. It is recommended that a 0.1 μF and a 0.01 μF decoupling capacitor be fitted between
Pin 8 and Pin 7.
9
GND1
10
GND1
11
GND2
Ground, Logic Side.
Ground, Logic Side.
Ground, Bus Side.
12
VISOOUT
Isolated Power Supply Output. This pin must be connected externally to VISOIN. It is recommended that a reservoir
capacitor of 10 μF and a decoupling capacitor of 0.1 μF be fitted between Pin 12 and Pin 11.
13
Y
Driver Noninverting Output
14
GND2
15
Z
Ground, Bus Side.
Driver Inverting Output
16
GND2
17
B
Ground, Bus Side.
Receiver Inverting Input.
18
A
Receiver Noninverting Input.
19
VISOIN
Isolated Power Supply Input. This pin must be connected externally to VISOOUT. It is recommended that a
0.1 μF and a 0.01 μF decoupling capacitor be fitted between Pin 19 and Pin 20.
20
GND2
Ground, Bus Side.
Rev. 0 | Page 7 of 20

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]