AT24C256N-10SU データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

AT24C256N-10SU

Two-wire Serial EEPROMs

Atmel Corporation 

Device

Operation

AT24C128/256

CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an external

device. Data on the SDA pin may change only during SCL low time periods (see Figure 4 on

page 9). Data changes during SCL high periods will indicate a start or stop condition as

defined below.

START CONDITION: A high-to-low transition of SDA with SCL high is a start condition which

must precede any other command (see Figure 5 on page 9).

STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition. After a

read sequence, the stop command will place the EEPROM in a standby power mode (see Fig-

ure 5 on page 9).

ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the

EEPROM in 8-bit words. The EEPROM sends a zero during the ninth clock cycle to acknowl-

edge that it has received each word.

STANDBY MODE: The AT24C128/256 features a low power standby mode which is enabled:

a) upon power-up and b) after the receipt of the STOP bit and the completion of any internal

operations.

MEMORY RESET: After an interruption in protocol, power loss or system reset, any two-wire

part can be reset by following these steps: (a) Clock up to 9 cycles, (b) look for SDA high in

each cycle while SCL is high and then (c) create a start condition as SDA is high.

7

0670T–SEEPR–3/07

Share Link: