X5328PI-2.7A データシートの表示（PDF） - Renesas Electronics
部品番号
コンポーネント説明
メーカー
X5328PI-2.7A Datasheet PDF : 21 Pages
| |||
X5328, X5329 (Replaces X25328, X25329)
SPI SERIAL MEMORY
The memory portion of the device is a CMOS Serial
EEPROM array with Intersil’s block lock protection. The
array is internally organized as x 8. The device features a
Serial Peripheral Interface (SPI) and software protocol
allowing operation on a simple four-wire bus.
The device utilizes Intersil’s proprietary Direct Write™
cell, providing a minimum endurance of 100,000 cycles
and a minimum data retention of 100 years.
The device is designed to interface directly with the syn-
chronous Serial Peripheral Interface (SPI) of many pop-
ular microcontroller families. It contains an 8-bit
instruction register that is accessed via the SI input, with
data being clocked in on the rising edge of SCK. CS
must be LOW during the entire operation.
All instructions (Table 1), addresses and data are trans-
ferred MSB first. Data input on the SI line is latched on
the first rising edge of SCK after CS goes LOW. Data is
output on the SO line by the falling edge of SCK. SCK is
static, allowing the user to stop the clock and then start it
again to resume operations where left off.
Write Enable Latch
The device contains a Write Enable Latch. This latch
must be SET before a Write Operation is initiated. The
WREN instruction will set the latch and the WRDI
instruction will reset the latch (Figure 3). This latch is
automatically reset upon a power-up condition and after
the completion of a valid Write Cycle.
Status Register
The RDSR instruction provides access to the Status
Register. The Status Register may be read at any time,
even during a Write Cycle. The Status Register is for-
matted as follows:
7
65432
1
0
WPEN FLB 1* 1* BL1 BL0 WEL WIP
*Bits (5,4) should be written as ‘1’ only.
The Write-In-Progress (WIP) bit is a volatile, read only
bit and indicates whether the device is busy with an
internal nonvolatile write operation. The WIP bit is read
using the RDSR instruction. When set to a “1”, a nonvol-
atile write operation is in progress. When set to a “0”, no
write is in progress.
Table 1. Instruction Set
Instruction Name Instruction Format*
Operation
WREN
SFLB
WRDI/RFLB
RSDR
WRSR
READ
WRITE
0000 0110
0000 0000
0000 0100
0000 0101
0000 0001
0000 0011
0000 0010
Set the Write Enable Latch (Enable Write Operations)
Set Flag Bit
Reset the Write Enable Latch/Reset Flag Bit
Read Status Register
Write Status Register (Block Lock, WPEN & Flag Bits)
Read Data from Memory Array Beginning at Selected Address
Write Data to Memory Array Beginning at Selected Address
Note: *Instructions are shown MSB in leftmost position. Instructions are transferred MSB first.
Table 2. Block Protect Matrix
WREN CMD Status Register Device Pin
Block
WEL
0
1
1
1
WPEN
X
1
0
X
WP#
X
0
X
1
Protected Block
Protected
Protected
Protected
Protected
Block
Unprotected Block
Protected
Writable
Writable
Writable
Status Register
WPEN, BL0, BL1,
WD0, WD1
Protected
Protected
Writable
Writable
FN8132 Rev 2.00
October 16, 2015
Page 6 of 21
Share Link: 