2N6989 データシートの表示（PDF） - Microsemi Corporation
部品番号
コンポーネント説明
メーカー
2N6989
Microsemi Corporation
2N6989 Datasheet PDF : 7 Pages
| |||
6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803
Website: http://www.microsemi.com
TECHNICAL DATA SHEET
Gort Road Business Park, Ennis, Co. Clare, Ireland.
Tel: +353 (0) 65 6840044 Fax: +353 (0) 65 6822298
Symbol
BH
LW
LW1
LT
BL
BW
BW1
Dimensions
Inches
Millimeters
Min Max Min Max
.200
5.08
.014 .023 0.36 0.58
.030 .070 0.76 1.78
.008 .015 0.20 0.38
.785
19.94
.220 .310 5.59 7.87
.290 .320 7.37 8.13
Notes
10
4, 10
10
6
6
9
Symbol
LS
LL
LL1
LO
LO1
LO2
α
Dimensions
Inches
Millimeters
Min Max Min Max
.100 BSC
2.54 BSC
.125 .200 3.18 5.08
.150
3.81
.005
0.13
.098
2.49
.015 .060 0.38 1.52
0° 15° 0° 15°
Notes
7, 11
8
8
5
NOTES:
1 Dimension are in inches.
2 Millimeters are given for general information only.
3 Index area: A notch or pin one identification mark shall be located adjacent to pin one and shall be located within the shaded
area shown. The manufacturer’s identification shall not be used as a pin one identification mark.
4 The minimum limit for dimension LW1 may be .023 inch (0.58 mm) for leads number 1, 7, 8 and 14 only.
5 Dimension LO2 shall be measured from the seating plane to the base plane.
6 This dimension allows for off-center lid, meniscus, and glass overrun.
7 The basic pin spacing is .100 inch (2.54 mm) between centerlines. Each pin centerline shall be located within ±.010 inch (0.25
mm) of its exact longitudinal position relative to pins 1 and 14.
8 Applies to all four corners (leads number 1, 7, 8 and 14).
9 Lead center when α is 0 degrees. BW1 shall be measured at the centerline of the leads.
10 All leads.
11 Twelve spaces.
12 No organic or polymeric materials shall be molded to the bottom of the package to cover the leads.
13 In accordance with ASME Y14.5M, diameters are equivalent to φx symbology.
FIGURE 1. Physical Dimension and Configuration for type 2N6989
T4-LDS-0177 Rev. 1 (101229)
Page 4 of 7
Share Link: