MAX4053ACSE データシートの表示（PDF） - Maxim Integrated
部品番号
コンポーネント説明
メーカー
MAX4053ACSE Datasheet PDF : 19 Pages
| |||
Low-Voltage, CMOS Analog
Multiplexers/Switches
ELECTRICAL CHARACTERISTICS—Single +5V Supply (continued)
(V+ = +4.5V to +5.5V, V- = 0V, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX
(Note 2)
UNITS
DSWIGIITTCAHL DI/OYNAMIC CHARACTERISTICS
Turn-On Time (Note 6)
tON
Figure 3
Turn-Off Time (Note 6)
Break-Before-Make Delay
Charge Injection (Note 6)
tOFF
tOPEN
Q
Figure 3
Figure 4
CL = 1nF, RS = 0Ω, VNO = 0V,
Figure 5
TA = +25°C
C, E, M
TA = +25°C
C, E, M
TA = +25°C
TA = +25°C
90 200
ns
275
60 125
ns
175
30
ns
2
10
pC
Off-Isolation
VISO
CL = 15pF, RL = 50Ω, f = 100kHz,
VNO = 1VRMS, Figure 6
TA = +25°C
<-90
dB
Channel-to-Channel
Crosstalk
VCT
CL = 15pF, RL = 50Ω, f = 100kHz,
VNO = 1VRMS, Figure 6
TA = +25°C
<-90
dB
Note 2: The algebraic convention is used in this data sheet; the most negative value is shown in the minimum column.
Note 3: ∆RON = RON(MAX) - RON(MIN).
Note 4: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal ranges; i.e., VNO = 3V to 0V and 0V to -3V.
Note 5: Leakage parameters are 100% tested at maximum-rated hot operating temperature, and guaranteed by correlation at
TA = +25°C.
Note 6: Guaranteed by design, not production tested.
6 _______________________________________________________________________________________
Share Link: 