5962-9669001HTA データシートの表示（PDF） - Micross Components

部品番号

コンポーネント説明

メーカー

5962-9669001HTA

128K x 8 FLASH UNIFORM SECTOR 5.0V FLASH MEMORY

Micross Components 

FLASH

AS29F010

GENERAL DESCRIPTION

The AS29F010 is a 1Mbit, 5.0 Volt-only FLASH memory

organized as 131,072 bytes. The AS29F010 is offered in a 32-

pin CDIP package. The byte-wide data appears on DQ0-DQ7.

The device is designed to be programmed in-system with the

standard system 5.0 Volt VCC supply. A 12.0 volt VPP is not

required for program or erase operations. The device can also

be programmed or erased in standard EPROM programmers.

This device is manufactured using 0.32 μm process

technology. It is available with access times of 50, 60, 70,

90, 120, and 150ns, allowing high-speed microprocessors to

operate without wait states. To eliminate bus contention the

device has separate chip enable (CE\), write enable (WE\), and

output enable (OE\) controls.

The device requires only a single 5.0 volt power supply

for both read and write functions. Internally generated and

regulated voltages are provided for the program and erase

operations.

The device is entirely command set compatible with the

JEDEC single-power-supply FLASH standard. Commands are

written to the command register using standard microprocessor

write timings. Register contents serve as input to an internal

state machine that controls the erase and programming circuitry.

Write cycles also internally latch addresses and data needed for

the programming and erase operations. Reading data out of

the device is similar to reading from other FLASH or EPROM

devices.

Device programming occurs by executing the program

command sequence. This invokes the Embedded Program

algorithm -- an internal algorithm that automatically times the

program pulse widths and verifies proper cell margin.

Device erasure occurs by executing the erase command

sequence. This invokes the Embedded Erase algorithm -- an

internal algorithm that automatically preprograms the array

(if it is not already programmed) before executing the erase

operation. During erase, the device automatically times the

erase pulse widths and verifies proper cell margin.

The host system can detect whether a program or erase

operation is complete by reading the DQ7 (Data\Polling) and

DQ6 (toggle) status bits. After a program or erase cycle has

been completed, the device is ready to read array data or accept

another command.

The sector erase architecture allows memory sectors to be

erased and reprogrammed without affecting the data contents

of other sectors. The device is erased when shipped from the

factory.

The hardware data protection measures include a low

VCC detector that automatically inhibits write operations dur-

ing power transitions. The hardware sector protection feature

disables both program and erase operations in any combination

of the sectors of memory, and is implemented using standard

EPROM programmers.

The system can place the device into the standby mode.

Power consumption is greatly reduced in this mode. The

device electrically erases all bits within a sector simultaneously

via Fowler-Nordheim tunneling. The bytes are programmed

one byte at a time using the EPROM programming mechanism

of hot electron injection.

PIN CONFIGURATION

PIN

DESCRIPTION

A0 - A16 17 Addresses

DQ0 - DQ7 8 Data Inputs/Outputs

CE\ Chip Enable

OE\ Output Enable

WE\ Write Enable

VCC +5 Volt Single Power Supply

VSS Device Ground

NC No Connect

LOGIC SYMBOL

AS29F010

Rev. 2.6 11/10

Micross Components reserves the right to change products or specifications without notice.

2

Share Link: